1. Remove all packaging material from the product and be careful not to throw away accessories that may be hidden
within the packaging material. If assembly is required, place the luminaire on a smooth non-scratch surface.
2. Remove the mounting bracket (C) from the luminaire (F) by loosening the screws (E) on the sides.
3. Use the mounting bracket (C) as a template to mark the screw positions on the wall.
4. Install the mounting bracket (C) onto the wall by using appropriately sized mounting screws (D) and anchors (A).
Ensure the screws (D) and anchors (A) used are suitable for the mounting surface and the surrounding environment.
5. Connect the mains supply wire to the terminal block (B). Ensure the wires are secure, and no bare wires are exposed.
Mains Supply Wire Luminaire Wire / Terminal block
Earth – Yellow/Green Yellow/Green or
Neutral – Blue or Black Blue or N
Live – Brown or Red Brown or L
6. Install the luminaire (F) back onto the mounting bracket (C) and secure it by tightening the screws (E) on the sides.
7. Install a gasket (H) onto the lamp holder (G), followed by the larger shade (J), followed by another gasket (K) and
secure using the lamp holder ring (L).
8. Install a globe (I - not included) into the lamp holder (G). Do not exceed the maximum wattage rating.
NOTE: If using a halogen globe, do not touch with your bare hands, use clean gloves or a tissue.
Using bare hands may reduce the life of the halogen globe.
9. Install the glass ball shade (M) onto the lamp holder (G).
10. After the installation, switch on the luminaire to test and enjoy your new lighting product.
