LOCATION OF CONTROLS
1. Hour Set Button
2. Minute Set Button
3. Alarm On/Off Switch
4. Alarm Volume Switch
5. Time Set Button
6. Alarm Set Button
7. Snooze Set Button
8. LED Display
9. PM(Afternoon) Indicator
10. AL ( Alarm) Indicator
POWER SUPPLY
Check the AC current is same as the instruction show on back plate of your unit and plugs the power cord
into the AC outlet. A blinking signal will appear indicating the time.
TIME SETTING
Press and hold the TIME SET BUTTON and then press the HOUR or MINUTE Button for hour and minute
adjustment of the time. Please make sure setting time is AM or PM has indication (AM dot will light in
the left upper corner indicating that the time is the PM range if your unit is 12 hour version type.)
SETTING THE ALARM TIME
Press and hold the ALARM SET BUTTON and the HOUR SET BUTTON or MINUTE SET BUTTON unit the
required alarm time is displayed. To display the alarm time, press the ALARM SET BUTTON
ALARM FUNCTION
When Slide the ALARM ON/OFF SWITCH to ON position. The ALARM INDICATOR will be lit and the
alarm will sound “Bi Bi”at the previously set alarm time. To stop the alarm sounding, slide the ALARM
ON/OFF SWITCH to OFF position. To slide the Alarm Volume Switch can adjust Alarm Volume and press
the SNOOZE button can pause current alarm. The Alarm will sound “Bi…Bi” after 9 minutes and press the
SNOOZE Button to be off again. It can be operated for this function repeatedly.
BATTERY BACKUP
Insert a 9 Volt battery in the battery compartment. Should there be a power failure, the clock will
continue to function. You will not see this however because the battery does not illuminate the clock
display. When the electric power turns on again, the display will indicate the correct time. For clarity alarm
clock does not work on battery. Replace the battery once a year.
SPECIFICATIONS
Frequency Range AM: 540-1600KHz
FM: 88~108MHz
2. Time Format: 24H format
3. AC Power: 230V~50Hz
4. DC Backup: 9V dry battery(1PCx PP-3)
5. Time Error: ±6 seconds/day under AC power supplied