Page is loading ...
Angle Mount
IP Camera Surveillance Accessory
Installation
Manual
1: Installation
Before you start, ensure that the hardware is in good condition and all assembly
parts are included.
Check that the mounting surface is strong enough to withstand three times the
combined weight of this mount and the camera.
Take care that all equipment is powered off during installation.
Important Note: To avoid damaging the surface of your dome camera during
installation, keep it away from walls and other objects. Do not remove the
protective coating from the dome until after the camera is installed and the
dome is in place.
If the product does not assemble properly, please contact technical support.
Compatibility
This can be used with Luma Surveillance 500- and 700-series IP dome cameras.
2: Box Contents
Before installing, familiarize yourself with the parts of your mount.
} Angle mount
} Drill template
} 5 wall anchors
} 4 mounting screws (to secure the camera to the angle mount)
Other Required Equipment
} Dome camera
} Drill with 7/32" or 5.5mm bit
} Phillips screwdriver
3: Installing the Mount
Place the enclosed drill template on the
mounting surface.
Note that the label TOP points to the
thickest portion of the angle mount.
Mounting in this manner allows
the camera to point straight down.
Change the orientation of the drill
template to align the camera as
desired.
Drill out the holes as marked. If
installing on a cement wall, secure the
mount in place using the wall anchors.
If mounting on a wood surface, use self-
piloting wood screws (not included).
Version 160802-1148
5: Attaching the Camera
Remove the dome from the camera (do not remove the protective cover from
the dome at this time).
Thread the camera wires through the housing and through the angle mount.
Attach the camera housing to the angle mount using three of the Phillips
screws provided with the cap mount.
Weatherproof the joint between the camera housing and the angle mount.
Support
If you need help, email support@SnapAV.com. For information, instructional
videos, support documentation, or ideas, visit our website.
5-Year Limited Warranty
This Luma Surveillance™ product has a 5-Year Limited Warranty. This warranty
includes parts and labor repairs on all components found to be defective in material
or workmanship under normal conditions of use. This warranty shall not apply to
products that have been abused, modified or disassembled. Products to be repaired
under this warranty must be returned to a designated service center with an assigned
return authorization (RA) number. Contact technical support for an RA number.
Copyright ©2016 Luma Surveillance. All rights reserved.
4: Aligning the Cap
The cap mount has several interior posts, however the Luma IP cameras use
the three outermost holes.
Install your dome camera
using these screw holes.
If you align the cable
hole of the camera
with the cable hole of
the angle mount, you
will have a neater install,
and the screw holes in the
camera and the angle mount
will align.
/
