21
iten
The mixture amount should not exceed the
max capacity of the bowl.
4. Rotatecounterclockwisetheliduntilblockedin
position, as shown in pic. 1
Make sure the food pusher is properly tted
into its housing on the cover.
5. Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
theconnectorhaveclicked.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Removetheknifebladerstbeforepouringout
themixture.
Don’t operate hard food for more than 10
seconds continuously.
To use the food processor attachment with shredding/
slicing inserts follow these instructions:
1. Firstofallmakesurethenon-slipbaseisxedto
the bottom of the bowl.
2. Fixthedesiredinsertintothebladessupportas
shown in pic. 2
3. Put the support into the pin on the bottom of the
bowl.
4. Rotatecounterclockwisetheliduntilblockedin
position, as shown in pic. 1
The fasteners must be locked in the two clip
positions, otherwise during operating the
bowl lid may rotate as the motor rotates.
5. Insert the bottom part of the motor unit into
the opening on the bowl lid, until the two small
buttons on the left and on the right of the
connectorhaveclicked.
6. Plug the appliance into the power outlet.
7. Put the food inside the feeding tube and push it
slowlywiththefoodpusher.Donotpushheavily.
8. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
To remove the blades support after using
pull with two ngers as shown in pic. 3.
CHOPPER ATTACHMENT (only on some
models) (C)
The chopper is perfectly suitable for hard
food, such as chopping meat, cheese,
onion, herbs, garlic, carrots, walnuts, almonds,
prunes etc.
Don’t chop extremely hard food, such as ice
cubes, nutmeg, coffee beans and grains.
1. Carefully remove the plastic cover from the
blade.
2. Fittheknifebladeonthepininthebowl-always
ttheknifebladebeforeaddingtheingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.
The mixture amount should not exceed the
max capacity of the bowl.
4. Close the lid.
5. Assemble the motor unit into the bowl lid until the
two small buttons on the left and on the right of
theconnectorhaveclicked.
6. Plug the appliance into the power outlet.
7. Rotate the speed-adjusting dial to select the
desired speed. Pressing and holding the ON/
OFF button, the attachment starts chopping
immediately. For maximum speed press the
TURBO button for a short time.
8. Removetheknifebladerstbeforepouringout
themixture.
Don’t operate hard food for more than 10
seconds continuously.
FOOD PROCESSOR ATTACHMENT
(only on some models) (D-E)
To use the food processor attachment as a chopper
follow these instructions:
1. Firstofallmakesurethenon-slipringisxedto
the bottom of the bowl.
2. Fittheknifebladeonthepininthebowl-always
ttheknifebladebeforeaddingtheingredients.
3. Cut the food into small pieces and put them into
the bowl.
A small amount of water can facilitate the
smooth running of the appliance.