Polaroid PL108-AF User manual
- Category
- Camera flashes
- Type
- User manual
Polaroid PL108-AF is a versatile flash unit designed for use with Canon, Nikon, Fuji, and Sony digital cameras. It features a variety of capabilities to help you take great photos in any situation.
Auto Focus Assist
The PL108-AF has a built-in auto focus assist beam that helps your camera's auto focus system in low light situations. This can be especially helpful when photographing moving subjects or in dimly lit environments.
Tilt/Bounce
The PL108-AF's unique tilt/bounce design allows you to bounce the flash off of walls or ceilings to create a softer, more flattering light. This can be useful for reducing harsh shadows and creating a more natural look in your photos.
Polaroid PL108-AF is a versatile flash unit designed for use with Canon, Nikon, Fuji, and Sony digital cameras. It features a variety of capabilities to help you take great photos in any situation.
Auto Focus Assist
The PL108-AF has a built-in auto focus assist beam that helps your camera's auto focus system in low light situations. This can be especially helpful when photographing moving subjects or in dimly lit environments.
Tilt/Bounce
The PL108-AF's unique tilt/bounce design allows you to bounce the flash off of walls or ceilings to create a softer, more flattering light. This can be useful for reducing harsh shadows and creating a more natural look in your photos.
Introduction
Your Polaroid PL108-AF is designed to give today’s digital photographer a new level of control and creativity. Thanks to its sophisticated technology it will seamlessly integrate with the
latest digital cameras as well as many older ones. This means you’ll be able to “focus” on creativity, secure in the knowledge that your Polaroid flash has the features and flexibility to
“make light” of even the most demanding of situations and environments.
To make sure that you get the most out of your flash, please take a few moments to familiarize yourself with its operation by reading this manual.
…And thank you for trusting the Polaroid brand for your pictures!
Studio Series
Auto Focus / TTL Flash
PL108-AF
USER GUIDE
A) LOADING THE BATTERIES
1 Make sure the power switch is at the "OFF" position
2 Slide the battery compartment cover forward so it
swings open
3 Insert 2 AA batteries making sure to follow the "+/-"
markings inside the compartment. For best results, use
fully charged batteries or fresh alkaline batteries, mixing
old and new batteries may affect operation
4 Close the compartment cover and slide it back so it
locks in place
B) MOUNTING YOUR POLAROID FLASH
ON YOUR CAMERA
1A FOR CANON, NIKON, & FUJI CAMERAS: hold the flash
so the back is facing you, and slide the flash into your
camera’s accessory shoe. Then press the locking button
on the bottom of your camera’s accessory shoe to lock
the flash into place.
1B FOR SONY AUTO LOCK SHOE CAMERAS: Slide the
flash forward into the camera’s accessory shoe until it
locks into place.
1C FOR SONYMULTI INTERFACE SHOE CAMERAS:
Loosen the lock ring. Slide the flash into camera's hot
shoe. Tighten the flash with the lock ring.
2 Slide the power switch to the “ON” position
E) SHOOTING WITH YOUR POLAROID FLASH
Because your flash is designed for seamless and fully automatic integration with your
Canon, Nikon, Fuji or Sony cameras digital camera, taking great flash photos is as easy as:
1 Making sure your camera is set up appropriately
2 Turning on your flash
3 Waiting for the “TEST/READY” light
4 Taking your photographs
Thanks to its advanced technology, your camera will automatically be controlling key flash
features like sync speed (which varies by model), and Through The Lens (TTL) functions
including, Auto-focus (AF)—and even Red-Eye reduction and light output --much like it
would for a built-in flash.
After you take your picture the ”AUTO OK” indicator will light up to confirm proper
flash exposure.
F) SPECIAL FEATURES—Designed To Help You Get The
Most Out Of Your Polaroid Flash!
1 AUTO-FOCUS "AF" ASSIST
Designed to assist your camera’s auto focus system in low light situations by projecting
a beam of red light on your subject.
To activate this handy feature, press lightly on your camera’s shutter release.
2 BUILT IN TILT/BOUNCE
Your Polaroid flash features a unique built in Tilt/Bounce design
which offers all the conventional bounce flash advantages--yet
does so while retaining the unit’s ultra compact design. Using
the Tilt/Bounce you’ll be able to add a new level of creativity
to your pictures as well as eliminate the sometimes harsh
unflattering lighting created by “Head-On” flash photographs.
To “bounce “ the flash; Simply tilt the head from its “normal”
90° angle to any of the preset increments up to 180°.
For best results bounce should be used in areas with lightly
colored ceilings of normal height
3 SLEEP MODE
To conserve power and extend battery life your Polaroid flash is designed to automatically
go into “Sleep” mode 3 minutes after the last time it was fired or powered “On”. While in
sleep mode, the READY lamp will be off. To take it out of “Sleep” mode simply press any
of the buttons and begin shooting. Despite the fact “Sleep” mode will conserve power,
always turn off your flash when you’re done using it.
4 FRONT AND REAR CURTAIN SYNCHRONIZATION
While your Polaroid flash supports front and rear curtain synchronization, this is usually
controlled through your camera. When Rear Curtain Sync is selected, the flash fires right
before the camera’s rear curtain closes (towards the ‘end’ of the exposure time), when
used in conjunction with a slow shutter speed the result is streaming light trails behind
the subject. While your flash has “FRONT/REAR” settings on the back, please check your
camera’s manual as many cameras will control the flash synch automatically.
5 RED EYE REDUCTION
As your flash is compatible with most cameras offering Red Eye Reduction, it will fire a
series of rapid “Pre Flashes” to eliminate annoying red eye from your photos
C) REMOVING YOUR POLAROID FLASH FROM YOUR CAMERA
1 Slide the power switch on the flash to the “OFF” position
2A FOR CANON, NIKON, & FUJI CAMERAS:
With the front of the flash away from you press and hold down both sides of the Release
Button on the flash’s mounting shoe while gently pulling the flash towards you.
2B FOR SONY AUTO LOCK SHOE CAMERAS:
With the front of the flash facing away from you, push the shoe release button and gently
slide the flash towards you
2C FOR SONYMULTI INTERFACE SHOE CAMERAS: Loosen the lock ring and remove the
flash off backwards.
D) TESTING YOUR POLAROID FLASH
1 Turn your flash On
2 Wait for the “TEST/READY” lamp to light up
3 To test, press the lit “TEST/READY” button, if the flash
fires, it’s ready for use, just wait for it to light up again
CONGRATULATIONS, You’re Now Ready To Begin Shooting!
NOTE: When you turn on your flash you should hear a high pitched ‘whistling’ sound for about 3
to 5 seconds. This is simply the sound of the flash charging and no cause for concern.
NOTE: Always make sure your flash is off before you insert or remove it from your camera
Tilted Reflector
Red Light
Mounting Foot
DSL288AF
SPEEDLITE
Battery Compartment
Cover
Test/Ready
Auto OK
ON/OFF Switch
Lock Button
Shoe Release Button
Type P
Type Sony MIS Foot
Type Sony Auto
Lock Shoe Foot
GETTING STARTED
Specifications*
Guide Number (ISO 100):
Five Position Tilted Reflector:
Power Source:
Flash Duration:
Recycling Time:
Number of Flashes:
Dimensions:
Net Weight:
24(m) / 78(ft)
0°/45°/60°/75°/90°
2 x 1.5V AA size batt. (R6, LR6)
1/2,000 - 1/40,000 sec.
0.3 - 10 sec. with fresh batteries
100 times with fresh batteries
Approx. 65 - 54 - 98mm
Approx. 127g (w/o batteries)
*Specifications are subject to change without further notice.
• The flash unit is not designed to work with camcorders
• Misfiring will sometimes occur when the power switch is turned on and off repeatedly.
If it happens, power off the flash unit for a few seconds before switching it on again.The
flash unit should then work as normal
• Do not leave or store the flash unit in temperatures exceeding 40°C. This might adversely
affect the internal structure or performance of the flash unit. Particularly, do not leave
the flash unit in automobiles during the summer.
• Remove the batteries if you do not intend to use the flash unit for a long period of time.
• The flash unit is not water-resistant. Rain and humid weather may cause irreparable
damages to the flash.
• The flash unit is composed of very sophisticated electronic parts. Therefore it should be
protected against shocks, falls or other improper handling.
• The flash unit contains a high voltage condenser. Do not try to open the housing or repair the flash yourself
• As is the case with all high quality technology products, do not clean the surface or internal areas with any
liquids, oil-based solutions, detergents or strong solvents, as these solvents may damage to the flash and void
your warranty.
!
Warranty Card
Limited Warranty: C&A Licensing LLC (”C&A”) warrants this product to the original consumer only and is not transferable. This warranty covers products that fail to function properly UNDER NORMAL USAGE, due to defects in material or workmanship. Your product will be repaired or replaced at no charge for parts or labor for a period as outlined below (the “Warranty Period”)
from your date of purchase. You will be responsible for shipping the product to C&A or its authorized servicer for warranty support.
Warranty Period
1 year limited warranty: NON-CARBON FIBER TRIPODS, CARD READERS, CASES, CLEANING ACCESSORIES, TRIGGER REMOTES, CORDS, FLASH UNITS, LED LIGHTS, BATTERY GRIPS, REPLACEMENT BATTERIES, LENS EXTENSION TUBES
5 year limited warranty: CARBON FIBER TRIPODS, ALL TERRAIN TRIPOD, LENS CAP, WHITE BALANCE CAPS, CAMERA FILTERS AND LENSES
What is Not Covered by Warranty
All other situations, including but not limited to damages or malfunctions not resulting from defects in material or workmanship and damages or malfunctions from other than normal use, including but not limited to, repair by unauthorized parties, tampering, modification or accident.
What To Do When Service Is Required
When returning your defective product (postage pre-paid) for service, your package should include:
1. Copy of original bill of sale
2. A detailed written description of the problem
3. Your return address and telephone number (Daytime)
4. The defective product
5. Mail to: C&A Licensing LLC, 2 Bergen Turnpike, Ridgefield Park, NJ 07660
-You may also visit www.polaroid.com for further assistance if necessary or call our technical support department toll free at 1-800-226-6534
THERE ARE NO EXPRESS WARRANTIES OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE, AND NO WARRANTIES WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, SHALL APPLY AFTER THE EXPRESS WARRANTY
PERIOD STATED ABOVE, AND NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE BINDING ON C&A. THIS WARRANTY IS THE EXCLUSIVE WARRANTY WITH RESPECT TO THE PRODUCT AND C&A IS THE EXCLUSIVE WARRANTY PROVIDER FOR THE
PRODUCT. REPAIR OR REPLACEMENT IS THE EXCLUSIVE REMEDY OF THE CONSUMER. IN NO EVENT WILL C&A, ITS MANUFACTURERS, DISTRIBUTORS OR PLR IP HOLDINGS, LLC BE LIABLE FOR ANY INCIDENTAL, DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR
LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) RELATED TO THIS PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMER’S RECOVERY AGAINST C&A SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY C&A. THIS WARRANTY
SHALL NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, or allow limitations on warranties, so the above limitations or exclusions may not apply to you. This Warranty gives you specific rights, and you may have other rights, which vary from state to state.
PLR IP Holdings, LLC, its licensees and affiliates, fully support all electronic waste initiatives. As responsible stewards of the environment, and to avoid violating established laws, you
should properly dispose of this product in compliance with all applicable regulations, directives or other governances in the area where you reside. Please check with local authorities or
the retailer where you purchased this product to determine a location where you can appropriately dispose of the product.
You may also go to www.polaroid.com to learn more about the specific laws in your area to locate a collection facility near your home.
If your electronic device has internal memory on which personal or other confidential data may be stored, you may want to perform a data sanitization process before you dispose of your
device to assure another party cannot access you personal data. Data sanitization varies by the type of product and its software, and you may want to research the best sanitization
process for your device before disposal. You may also check with your local recycling facility to determine their data sanitization procedures during the recycling process.
Polaroid, Polaroid & Pixel, Polaroid Classic Border Logo, and Polaroid Color Spectrum are trademarks of PLR IP Holdings, LLC, used under license. All other trademarks are the
property of the respective owner, who has not sponsored, endorsed or approved this product. PLR IP Holdings, LLC does not manufacture this product or provide any
Manufacturer's Warranty or support.
For warranty information and technical support please call 1-800-226-6534 or visit www.polaroid.com
MADE IN CHINA
© 2014 All Rights Reserved
Distributed by: C&A Licensing LLC
2 Bergen Turnpike, Ridgefield Park, NJ 07660
-
1
Polaroid PL108-AF User manual
- Category
- Camera flashes
- Type
- User manual
Polaroid PL108-AF is a versatile flash unit designed for use with Canon, Nikon, Fuji, and Sony digital cameras. It features a variety of capabilities to help you take great photos in any situation.
Auto Focus Assist
The PL108-AF has a built-in auto focus assist beam that helps your camera's auto focus system in low light situations. This can be especially helpful when photographing moving subjects or in dimly lit environments.
Tilt/Bounce
The PL108-AF's unique tilt/bounce design allows you to bounce the flash off of walls or ceilings to create a softer, more flattering light. This can be useful for reducing harsh shadows and creating a more natural look in your photos.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Polaroid PLCHUOLY Operating instructions
-
-
-
-
-
-
-
-
-
