Install the Charging Dock
Place the Charing Dock against the
wall.
Connect the Adapter to Charging
Dock and outlet.
Leave an area on each side of
Charging Dock (1x1x1.5m/3.3x3.3x5ft)
Wake up your Robot
Remove the two protective foams
on the both sides of body.
Turn on the power switch at the
side of body.
I: ON O: OFF
Charging your Robot
2 ways to charge
a. Use charging dock
b. Use adpater directly
a. When charging, flashes (red).
b. Charging completed, turns green.
Charging status:
*Note: Fullly charge it when you just receive it.
3.3ft
3.3ft
5ft
a.
b.
