SafeWaze 019-8031 Owner's manual

Hello! I've reviewed the SafeWaze 019-8031 HLL Tension Indicator Instruction Manual. This manual provides details on how to properly install and use the tension indicator for horizontal lifeline systems. It includes information about tension levels based on span length and identifies over-tensioning using a color-coded display. I'm ready to answer any questions you have about the product and its use.
What is the purpose of the Tension Activation Window?

Where should the tension indicator be installed?

What does the color red indicate while tensioning the system?

019-8031

HLL Tension Indicator Instruction Manual

SafeWaze 225 Wilshire Ave SW Concord, NC 28025

Figure A Figure BFigure C

The SafeWaze 019-8031 HLL Tension Indicator is designed for easy installation and use in most

Horizontal Lifeline Systems. Built with a Tension Activation Window to help identify when tension is being

applied to the unit. This Tension Indicator simplifies the setup and tensioning of Horizontal Lifelines by

providing an easy to read, color-coded indicator and chart, which corresponds to different types of HLL

systems in various spans.

It is recommended that during installation, the tension indicator be installed on the same end of the

system as the tensioning device. This allows the installer to easily see when the system is properly

tensioned.

Figure A indicates proper tension for a span up to 60' in length. Figure B indicates proper tension for a

span length greater than 60' in length. Figure C indicates over tensioning of the system. In the event

that red is indicated while tensioning the system, simply reduce the tension until the red line on the

indicator is no longer visible. Figure D illustrates a typical HLL installation including the tension indicator.

Figure D

220-00030