2. Rock Hard 4X4
  3. RH5011

Rock Hard 4X4 RH5011 Installation guide

  • I have reviewed the provided installation instructions for the ROCKHARD Vacuum Pump Relocation Bracket. This document outlines how to relocate the vacuum pump using a new bracket, including removing the factory bracket, installing the new bracket, and reinstalling the pump. I'm ready to answer your questions about the required steps, hardware, and checks
  • What should be removed first?
    What should be cut?
    What size bolt should be used to install the bracket?
    How many bolts are used to install pump?
    What should be checked after installing the pump?
.
Vacuum Pump Relocation Bracket
1. Remove vacuum pump from factory bracket.
2. Cut front factory bracket as shown in Photo 1. Completely remove this tab
with stud.
Photo 1
3. Install new bracket using 1-6mmx1.00x20mm bolt and factory stud as
shown in photo 2. Use 6mm nylock nut on factory stud.
Photo 2
4. Install pump as shown in photo 2 using 2-6mmx1.00x35 bolts and flange
nuts removed from factory studs. Check clearance at steel line above pump
and clearance below pump above stabilizer. Bend bracket if necessary.
Tech Support Line (308) 750-4690
1
/