All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
PLANNING
GUIDE
COMBINATION INSTALLATIONS
Drop-In Cooktop/
Single Wall Oven
Document # PGCI-019
Revised 12/07/11 Page 1/1
Dacor DO, EO, EORS,
MOH, MORS, MOV, RO or ROV
series single wall oven
36"
(91.4 cm)
typical
counter height
A
Minimum from
finished
countertop to
oven platform
Non-combustible material
Combustible material,
non-combustible material
recommended
E
D
C
Wall oven
platform,
see wall oven
planning guide
24" (61.0 cm)
Minimum interior cabinet depth
B
Cutout depth
Cabinet face
Cabinet face
Front of countertop
Drop-in cooktop, approved models:
DCT, ETT, MET, RGC or SGM series only
1 1/2" (3.8 cm)
min. countertop
thickness
CUTAWAY SIDE VIEW
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
Cooktop
Model No.
A B C Min. D Min.
DCT 30 7/8” (78.4 cm) 19 5/8” (49.8 cm) 3 1/4” (8.3 cm) 1 5/8” (4.1 cm)
ETT, MET Series 32 5/8” (82.8 cm) 19 3/4” (50.2 cm) 2 1/4” (5.7 cm) 1” (2.5 cm)
SGM Series 30 7/8” (78.4 cm) 19 3/4” (50.2 cm) 2 7/8” (7.3 cm)* 1 3/8” (3.5 cm)
RGC Series 30 7/8” (78.4 cm) 19 3/4” (50.2 cm) 2 7/8” (7.3 cm) 1 7/8” (4.8 cm)
Oven
Model No.
E Min.
DO Series 1 5/8” (4.1 cm)
EO/MO Series 1 7/8” (4.8 cm)
EORS/MORS Series 1 1/8” (2.9 cm)
RO Series 1” (2.5 cm)
NOTE: When installing a gas cooktop, the width of the cooktop
must be equal to or wider than the wall oven width.
PRELIMINARY
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• All appliances must be installed in accordance with the
accompanying installation instructions.
IMPORTANT: Cooktop model SGM464GG
is not approved for this application.
* 2 3/8" (6.0 cm) on model SGM365
