Electrolux EFC70001X User manual

Brand: Electrolux

Model: EFC70001X

Category: Cooker hoods

Type: User manual

This manual is also suitable for

Electrolux EFC70001X is a cooker hood designed to eliminate kitchen odors and provide clean air while cooking. It features adjustable fan speeds, allowing you to choose the right level of extraction for your cooking needs. The metal grease filters effectively capture grease particles, and can be easily removed and cleaned in a dishwasher or by hand. With a sleek design and powerful performance, the Electrolux EFC70001X is a great choice for modern kitchens.

USER MANUAL

EFC60001

EFC90001

We were thinking of you

when we made this product

electrolux 3

RECOMMENDATIONS AND SUGGESTIONS 5

CHARACTERISTICS 6

INSTALLATION 8

USE 11

MAINTENANCE 12

Welcome to the world of Electrolux

Thank you for choosing a ﬁ rst class

product from Electrolux, which hopeful-

ly will provide you with lots of pleasure

in the future. The Electrolux ambition is

to offer a wide variety of quality prod-

ucts that make your life more comfort-

able. You ﬁ nd some examples on the

cover in this manual. Please take a few

minutes to study this manual so that

you can take advantage of the beneﬁ ts

of your new machine. We promise that

it will provide a superior User Experi-

ence delivering Ease-of-Mind.

Good luck!

4 electrolux Recommendations and Suggestions

Installation

• The manufacturer will not be held li-

able for any damages resulting from

incorrect or improper installation.

• The minimum safety distance be-

tween the cooker top and the extrac-

tor hood is 650 mm.

• Check that the mains voltage corre-

sponds to that indicated on the rating

plate ﬁ xed to the inside of the hood.

• For Class I appliances, check that the

domestic power supply guarantees

adequate earthing.

Connect the extractor to the exhaust

ﬂ ue through a pipe of minimum diam-

eter 120 mm. The route of the ﬂ ue

must be as short as possible.

• Do not connect the extractor hood to

exhaust ducts carrying combustion

fumes (boilers, ﬁ replaces, etc.).

• If the extractor is used in conjunction

with non-electrical appliances (e.g.

gas burning appliances), a sufﬁ cient

degree of aeration must be guaran-

teed in the room in order to prevent

the backﬂ ow of exhaust gas. The

kitchen must have an opening com-

municating directly with the open air in

order to guarantee the entry of clean

air.

Use

• The extractor hood has been de-

signed exclusively for domestic use to

eliminate kitchen smells.

• Never use the hood for purposes

other than for which it has ben de-

signed.

• Never leave high naked ﬂ ames under

the hood when it is in operation.

• Adjust the ﬂ ame intensity to direct it

onto the bottom of the pan only, mak-

ing sure that it does not engulf the

sides.

• Deep fat fryers must be continuously

monitored during use: overheated oil

can burst into ﬂ ames.

• Do not ﬂ ambè under the range hood;

risk of ﬁ re

• The hood should not be used by chil-

dren or persons not instructed in its

correct use.

Maintenance

• Switch off or unplug the appliance

from the mains supply before carrying

out any maintenance work.

• Clean and/or replace the Filters after

the speciﬁ ed time period.

• Clean the hood using a damp cloth

and a neutral liquid detergent.

The symbol on the product or on its

packaging indicates that this product may

not be treated as household waste. Instead

it shall be handed over to the applicable

collection point for the recycling of electrical

and electronic equipment. By ensuring this

product is disposed of correctly, you will help

prevent potential negative consequences for

the environment and human health, which

could otherwise be caused by inappropriate

waste handling of this product. For more

detailed information about recycling of this

product, please contact your local city ofﬁ ce,

your household waste disposal service or

the shop where you purchased the product.

RECOMMENDATIONS AND SUGGESTIONS

Characteristics electrolux 5

Dimensions

CHARACTERISTICS

750 min

1140 max

S30_01_n

600

700

900

290

590 min

275

180

670

670 min

920 max

Components

Ref. Q.ty Product Components

F 1 Adapting ring ø 120-125 mm

G 1 Reducer Flange ø 150-120 mm

H 1 Air Outlet Connection

Ref. Q.ty Installation Components

C 2 Upper Chimney Section Fixing

Brackets

Q.ty Documentation

1 Instruction Manual

6 electrolux Installation

INSTALLATION

The cooker hood must be installed cen-

trally over a cooking appliance. The mi-

nimum distance between the cooking

surface and the metal grease ﬁ lters on

the underside of the hood must be at

least 650mm.

To install the hood proceed as follows:

1) Drill six 8mm diameter holes at X1-

X2-J and insert the plastic rawl plugs

supplied as illustrated ensuring the

brackets are ﬁ tted as shown in the

blow up.

2) Secure the two brackets C to the wall

inserting two of the screws supplied

through the two holes on line X1-X2

as illustrated .

3) Slide the canopy down the wall to

locate the key hole over the washer

then secure the canopy to the wall

by inserting two of the screws sup-

plied through the two outer holes in

the rim of the canopy J1 and J2 as

illustrated

750 min

1140 max

S30_01_n

600

700

900

290

590 min

275

180

S30_02_n

S30_03_n

670

920 max

670 min

Installation electrolux 7

Connections

Ducted Version Air Exhaust system

When installing the ducted version,

connect the hood to the chimney using

either a ﬂ exible or rigid pipe ø 150 or

125 mm, the choice of which is left to

the installer.

• To install a ø 125 mm air exhaust con-

nection, insert the reducer ﬂ ange G

on the hood body air outlet and the

adapting ring ø120-125 F on the re-

ducer ﬂ ange.

• Fix the pipe in position using sufﬁ cient

pipe clamps (not supplied).

• Remove any activated charcoal ﬁ l-

ters.

Connection in Recycling Version

• When the hood is ﬁ tted in the recircu-

lation mode the Air Outlet Connection

H should be ﬁ tted as illustrated .

• Fit the (optional) charcoal ﬁ lters by

repeating the following operation on

each side of the motor housing. Place

the two key hole slots in the ﬁ lter and

turn the ﬁ lter clockwise to lock the

ﬁ lter in position.

WARNING: It is a possible ﬁ re hazard if

the metal grease ﬁ lters are not cleaned

and the charcoal ﬁ lters replaced regu-

larly.

ø150

ø120

ø125

Connection to the Mains

WARNING: Double insulated do

not earth

• Before connecting to the mains sup-

ply ensure the mains voltage corre-

sponds to the voltage on the rating

plate inside the hood.

• This appliance is ﬁ tted with a 2 core

mains cable and must be permanently

connected to the electricity supply via

a double-pole switch having 3mm

minimum contact gap on each pole.

8 electrolux Installation/Use

Chimney assembly

Upper Chimney

• To ﬁ t the upper chimney A, place the

top edge of the chimney over the

bracket C as illustrated and secure

the chimney using two of the 2.9mm

self tapping screws provided.

• The distance H in the height between

the ﬁ xing holes X1 and X2 is deter-

mined by the height of the upper

chimney A.

Lower Chimney

• To ﬁ t the lower chimney B, apply slight

force to the two rear edges to increase

the width of the apperture, then sleeve

the chimney B over the chimney A as

illustrated.

USE

The cooker hood functions are control-

led by a series of slider or push button

switches mounted on the front of the

hood and control the worktop lighting

and fan motor speeds. This cooker

hood will not remove steam.

1) SLIDER SWITCHES

- A switch controls the wotktop light-

ing - ON/OFF.

- A switch controls the fan speeds -

OFF/ON-1-2-3.

- The red neon lamp illuminates when

the motor is switched ON .

S30_08_n

2) SPEED SETTINGS

- 1/Low should be selected when sim-

mering or when using only one pan.

- 2/Medium should be selected for

cooking when using up to four pans.

- 3/High should be selected when frying

or cooking food with a strong odour.

Maintenance electrolux 9

MAINTENANCE

N.B. Before carring out any kind of

maintenance, cleaning or replacing lam-

ps, disconnect the hood from the mains

supply.

Lighting

40 W incandescent light

• Remove the metal grease ﬁ lters.

• Unscrew the bulbs and replace them

with new ones having the same char-

acteristics.

• Replace the metal grease ﬁ lters.

Filters

• The metal grease ﬁ lter should be

cleaned every two months or more

frequently if the hood is used consist-

ently and can be cleaned in a dish-

washer or by hand using a mild deter-

gent or liquid soap. When replacing,

ensure that they are dry.

• The charcoal ﬁ lter cannot be washed

and should be replaced at least every

2 months or more frequently if the

hood is used consistently.

Cleaning

When cleaning the hood, it is recommen-

ded to use a damp cloth and mild liquid

household

cleaner. Never use abrasive cleaning ma-

terials.

ATTENTION: The manufacturer declines all

responsibility for any damage or injury

caused as a result of not following the in-

structions for installation, for maintenance

and replacement times of ﬁ lters indicated (in

order to avoid a possible risk of ﬁ re when the

ﬁ lters are saturated with grease).

www.electrolux.com

436003751_04 - 070831

Electrolux EFC70001X User manual

Brand: Electrolux

Model: EFC70001X

Category: Cooker hoods

Type: User manual

This manual is also suitable for

Download PDF

report

Electrolux EFC70001X User manual

This manual is also suitable for

Electrolux EFC70001X User manual

Related papers

Other documents