EuroLite FLASHLIGHT DJ-CONTROLLER Operating Instructions Manual

EuroLite
Brand
EuroLite
Model
FLASHLIGHT DJ-CONTROLLER
Type
Operating Instructions Manual
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
4
OPERATING INSTRUCTIONS
)ODVKOLJKW'-&RQWUROOHU
For your own safety, please read this user manual carefully before you initial start-up.
Every person involved with the installation, operation and maintenance of this device has to:
- be qualilfied
- follow the instructions of this manual
INTRODUCTION
Thank you for having chosen a FLASHLIGHT DJ-CONTROLLER switchpanel. You will see you acquired a
powerful and versatile device.
Unpack your FLASHLIGHT DJ-CONTROLLER.
Before you initial start-up, please make sure that there are no damages caused by transportation. Should
there be any, consult your dealer.
SAFETY INSTRUCTIONS
This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer
will not accept liability for any resulting defects or problems.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect
from mains immediately. Please let the device be checked by a qualified service technician before you
operate it again. Any damages caused by liquids having entered the device are not subject to warranty!
Never let the AC-cord come into contact with other cables! Handle the AC-cord and all AC-connections with
particular caution! Never touch these parts with wet hands!
Keep away from heaters and radiators!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Make sure that the available voltage is not higher than stated on the device.
Please consider that damages caused by manual modifications to the device are not subject to warranty.
Keep away children and amateurs!
5
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
OPERATING DETERMINATIONS
You can install the device at any desired place. Please make sure that the device is not exposed to extreme
heat, moisture or dust. There should not be any cables lying around. You endanger your own and the safety
of others!
Do not operate the device in extremely hot (more than 30°C) or extremely cold (less than 5°C) surroundings.
Keep away from direct insolation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Caution: In order to coply with CE-standards, it is absolutely necessary to plug the filter for Geni flashtubes
between the wall socket and the controller.
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
If you want to move the device please use the original packaging in order to avoid transport damages.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
FEATURES
• Four modes with the following functions: forward, backward, reverse, crossover, autoreverse and flash.
• Speed control an frequency control via autospeed-control or via manual control through trigger-button
• Maximum charge 40 flashtubes (10 tubes per zone)
• Unlimited branching for each zone
• Rugged aluminium housing
FUNCTIONS
Front panel:
1. ON/OFF-switch with LED-display
2. Flash speed control
3. Function selector
4. Flash rate control
6
5. Auto/Manual-switch
6. Trigger-button for individual flashes (The button has to be set to Manual)
Rear panel
TECHNICAL SPECIFICATIONS FLASHLIGHT DJ-CONTROLLER
Power supply: 230 V/50 Hz
Max. total load: 10 Ampere
Dimensions:
45 x 135 x 126 mm
Weight:
1 kg
Please note: All specifications are subject to change withour prior notice.
Errors and omissions excepted.
7/98 ©
8. Power cord
9. Fuseholder
10. IEC socket for
connecting the flashtubes
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

EuroLite FLASHLIGHT DJ-CONTROLLER Operating Instructions Manual

EuroLite
Brand
EuroLite
Model
FLASHLIGHT DJ-CONTROLLER
Type
Operating Instructions Manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents