APC AR8440A User manual

Category
Rack accessories
Type
User manual
NetShelter Vertical Cable Organizer—AR8440A, AR8441A
Inventory
Tools Required
Overview
The vertical cable organizer can be installed on all APC 4-post and 2-post racks. On all racks, the
installation procedures are the same with the exception of the number and type of fasteners used.
Number of fasteners required for 4-post racks (AR203,
and AR204):
Eight M8 × 16mm hex head cap screws
Eight M8 lock washers
Number of fasteners required for 2-post racks (AR200,
and AR201), and 4-post rack (AR202):
12 M8 × 16mm hex head cap screws
12 M8 lock washers
12 M8 flat washer
12 M8 hex nut
M8 × 16mm hex
head cap screw (12)
M8 hex nut (12) M8 flat washer (12)
M8 lock washer (12) Edge grommet (25.5 inches) Upper and lower vertical
cable organizer (1 each)
13mm wrench or socket wrench
NetShelter Vertical Cable Organizer—AR8440A, AR8441A
990-1448
07/2003
Hole patterns
The vertical cable organizer has two types of
mounting hole configurations. The type of rack
the vertical cable organizer is installed on will
determine which one you will use. Refer to the
hole alignment diagram to choose the correct hole
configuration.
Installation
1. Position the upper vertical cable organizer against the rack’s post and align the mounting holes.
2. Insert the appropriate fastener into one of the upper holes to hold the organizer in position.
3. Insert the lower cable organizer into the upper cable organizer and align the holes with the hole
in the rack.
4. Insert the fasteners in the remaining mounting holes.
5. Measure, cut, and apply the edge grommet material to the edge of the vertical cable organizer
where the upper and lower halves come together.
AR200, AR201, AR202
AR203, AR204
  • Page 1 1
  • Page 2 2

APC AR8440A User manual

Category
Rack accessories
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI