MULTIPLEX Soda Tower Water Valve Kit EI216697EI216697 Installation guide

MULTIPLEX
Brand
MULTIPLEX
Model
Soda Tower Water Valve Kit EI216697EI216697
Category
Sanitary ware
Type
Installation guide
Instruction Sheet
Subject: Water Valve Kit
Scope: Tower Models 116, 116X, 156, 156X
1 of 3
DocumentNumber:EI216697 09/16/2019
MULTIPLEX
2100 FUTURE DRIVE, SELLERSBURG, IN 47172
844-724-CARE
WWW.MULTIPLEXBEVERAGE.COM
Refreshing the Experience
Item Part No. Description Quantity
1* 00111005 Adaptor,1/8MPTx5/16Stem 1
2* 00208803 Cover,3/8Collet 2
3* 00209317 Adaptor,1/8MPTx3/8Tube 1
4* 00210752 Adaptor,1/4Barbx3/8Stem 1
5* 00211658 Valve,TwoWay,24VAC 1
6* 00213885 Elbow,3/8Tubex5/16Tube 1
7 00216696 WireHarness,WaterValve 1
8 00213146 WireHarness,PortionControl 1
9 00216728 Spacer,Standoff,1/2" 2
10 00216730 MountingBracket,156Tower 1
11 00216731 EscutcheonPlate,156Tower 1
12 00216732 SpoutAssembly,156Tower 1
13 00216735 Spout,146Tower 1
14* 00551303 Button,WaterFlow 1
15 00800533 Bushing,7/8"Hole 1
16 00850701 HexNut,#6-32 2
17 00851214 Screw,#10x1" 2
18 00853004 Screw,#10x1/2" 2
19 PE500651 Tube,SpoutSleeve 1
20 PE021230 Tubing,Polyethylene 3 ft.
21 00855114 Tab-Clamp,#105 2
22 00855128 Tab-Clamp,#198 2
23 00861317 Splice,1/2x1/4Barb-Stem 1
*Theseitemsarepre-assembled.
2 of 3
DocumentNumber:EI216697 09/16/2019
Subject:WaterValveKit
n
Caution
DANGER OF ELECTRICAL SHOCK
Disconnect and lock out all electrical power sourcesbefore
performingserviceormaintenanceonthismachine--except
whenelectricaltestsarebeingperformedbyqualifiedservice
personnel.
n
Caution
AdheretoallNationalandLocalPlumbingandElectrical
SafetyCodes.
n
Caution
Turn “off” incoming electrical service switches when
servicing,installing,orrepairingequipment.
n
Caution
Use caution when handling metal surface edges of all
equipment.
INSTALLATION OF FRONT DRAW TOWER
1. Turn“off”thepowerswitchonthedispensingtower.
2. Removetopcoverandrearcoverpanels.
3. Removewireharnessconnectingthefarleftdispensing
valve(labeled“#1”)totheelectronicportioncontrol
boardandthefront-mountedwaterswitch.
4. Connecttheleftdispensingvalvetotheportioncontrol
boardwiththenewharnessprovidedinthiskit.
5. Assemblethewatervalvetothemountingplatedirectly
behindtheleftdispensingvalve.Use1/2”spacersunder
thevalve.
6. Connectthewatervalvewireharnesstothevalveand
frontmountwaterswitchcommonandnormallyopen
terminals.
7. Inserttheplasticbushingintheholeadjacenttothe
watervalveandroutetheconnectorendofcorddown
throughthebushing.Disconnectone(1)ofthetower
powersupplycordsandreconnectinserieswiththe
watervalvecord.
8. Insertscribedendofthestainlesssteelspouttube
intotheoutletfittingofthewatervalvewiththespout
projectingdownthroughtheholelocatedinthesplash
panelbetweenthefirstandtheseconddispensing
valves.
9. Makeappropriatewatersupplyconnectiontothewater
inlettube.
10.Turnthewatersupply“on”andcheckforleaks.
11.Turn“on”thepowerswitchandtestinstallationby
pressingthefrontmountedwaterswitch.Watershould
dispense.
12.Replacetowerrearpanelandthetopcover.
INSTALLATION OF THE PASS-THRU TOWER
1. Turn“off”thepowerswitchonthedispensingtower.
2. Removethetopcover,“wide”stanchionaccesspanel,
andcoverplateconcealingthefamilyofholesinthe
frontedgeofstanchion.
3. Removewireharnessconnectingthedispensingvalve
(adjacenttothe“wide”stanchion)totheelectronic
portioncontrolboardandthestanchion-mountedwater
switch.
4. Connectthewatervalvewireharnesstothevalveand
frontmountwaterswitchcommonandnormallyopen
terminals.
3 of 3
DocumentNumber:EI216697 09/16/2019
Subject:WaterValveKit
5. Insertthespoutassemblyintotheoutletfittingofthe
watervalveandattachthemountingbracketwith#10x
1/2”screws.
6. Guidespoutthroughthelowerrectangularholein
thestanchionandthroughtheholeintheEscutcheon
plate.AlignthethreadedstudsontheEscutcheonplate
throughtheholesinthestanchionandthemounting
bracket.Securewith#6-32hexnuts(provided).
7. Connectthewatervalvewireharnesstothevalvecoil
andthewaterswitchinthestanchionabovethewater
valve.
8. Disconnectone(1)ofthetowerpowersupplycordsand
reconnectinserieswiththewatervalvecord.
9. Maketheappropriatewatersupplyconnectiontothe
watervalveinlettube.
10.Turn“on”thewatersupplyandcheckforleaks.
11.Turnthepowerswitch“on”andtesttheinstallationby
pressingthewaterswitchabovethespout.Watershould
dispense.
12.Replacethestanchionaccesspanelandthetopcover.
  • Page 1 1
  • Page 2 2
  • Page 3 3

MULTIPLEX Soda Tower Water Valve Kit EI216697EI216697 Installation guide

MULTIPLEX
Brand
MULTIPLEX
Model
Soda Tower Water Valve Kit EI216697EI216697
Category
Sanitary ware
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents