Power
®
Alpha Technologies reserves the right to make changes to the products and information contained in this document without notice.
Copyright © 2015 Alpha Technologies. All Rights Reserved. Alpha
®
is a registered trademark of Alpha Technologies. member of The Alpha Group™ is a trademark of Alpha Technologies.
745-997-C0-001, Rev. A1 (10/2015) To report errors in this document, send email to T[email protected]
For more information visit www.alpha.com
United States Bellingham, Washington Tel: 360 647 2360 Fax: 360 671 4936
Canada Burnaby, British Columbia Tel: 604 430 1476 Fax: 604 430 8908
member of The Group
TM
SPI Installation Instructions
Tools Required:
• Channel lock pliers
• 1" torque wrench set
to 130 in/lbs
Assembly Time:
Approx. 10 minutes
RF SPI Mounting
Location
Secondary
SPI Mounting
Location
Attach the
channel
lock pliers
Primary SPI
Mounting
Location
Optional
locations*
(if needed)
1.
Locate opening for SPI
installation. A knockout is
reserved for installation of a
secondary SPI (if required).
2.
Hold the SPI in place using
channel lock pliers while
tightening the nut. Torque to
130 in/lbs.
3.
Connect SPI to power supply.
For wiring instructions, refer
to the XM Series 2 Technical
Manual, which can be
downloaded at www.alpha.com.
*If the SPI is mounted in
the location at the top of
the enclosure, the SPI
must be mounted vertically
to allow space for other
hardware.
-
1
Alpha Northern PWE Series Installation guide
- Type
- Installation guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Alpha UPE Enclosure Installation guide
-
-
-
-
-
-
-
-
-
Alpha PWE Enclosure Owner's manual
