V-ZUG 51017 Installation guide

Type
Installation guide
Installation instructions
De Luxe KLi Refrigerator
Built-in EURO 60
J51017.051-1
23.1.14
7
These installation instructions apply to model: 51017
Information on the necessary mains voltage, type of current and fuse protection can be taken from the identification plate.
Push the appliance into the niche. Secure to the cabinet with 1 screw (included in the scope of delivery) through each hinge. Then,
screw the appliance to the cabinet at the top with 2 chipboard screws (included in the scope of delivery) each through the fixing bar.
Operate the appliance in accordance with the operating instructions supplied.
Ensure that the appliance is switched off if it is not intended that the appliance be used immediately after installation.
Validity
This appliance is considered to be suitable for use in countries having a warm damp equable climate (WDaE). It may also be
used in other countries. If used in warm damp equable climated countries, the appliance is to be supplied through a residual
current device (RCD) having a rated residual operating current not exceeding 30 mA.
General notes
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
If installing into combustible material, the guidelines and safety standards for low voltage installations and fire protection must
be strictly observed.
Electrical connections
Electrical connections must be carried out by suitably qualified personnel in accordance with the guidelines and safety
standards for low voltage installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are
permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation.
After installation, live parts and cables with basic insulation must not be accessible.
Check old installations.
Installation
The door opening can be changed from right to left up until the point when the appliance is installed in the niche.
Installation instructions
De Luxe KLi Refrigerator
Built-in EURO 60
J51017.051-1
23.1.14
8
Built-in, integratable door
* Allow a gap – at the top and bottom – less than the width of the appliance to ensure proper ventilation
(sheets 5–13 in the technical guide on kitchen planning and design from the Swiss Kitchen Association (KVS)).
Shadow gaps alone – even if extended over several elements – are not sufficient.
a Niche overlap
w
For door panel thickness greater than 19 mm, use hinge bolts supplied.
This restricts the opening radius to a maximum of 90°.
100
=
=
120
1524 =12/6
+2
0
min. 50
min. 200 cm² min. 200 cm²
min. 4
a
a
1524 =12/6
+2
0
16–20
Identification plate located
left next to salad crisper
1850 (SMS norm) flush-mounted power socket, «type 13»
Positioned ABOVE
standard
Positioned BELOW
also possible
Width of
element 600
Appliance 1522
Appliance 545 Door panel
Ventilation cross-section *
Door panel
Niche
Niche
1524+2a
max. 594
200
430
~602
100˚
A
16–20
Filler strip H7.1755
(request when ordering appliance)
Detail A
Niche
560–568
Niche
550
Appliance
548
Ventilation
Door panel
w
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18

V-ZUG 51017 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI