SEM 0201 OMD Operating instructions

Security Engineered Machinery Co., Inc

OPERATIONAL & MAINTENANCE MANUAL

SEM Model 0201 OMD

REV: 1

Security Engineered Machinery Co., Inc

NATIONWIDE SERVICE

Phone Toll Free 1(800)225-9293

Email: [email protected]

Fax: (508)366-6814

Website: WWW.SEMSHRED.com

***IMPORTANT SAFETY PROCEDURES***

Your new CD/DVD shredder incorporates powerful, heavy duty cutting mechanisms, serious and permanent

injury may result if proper precautions are not followed.

1. This equipment should never be operated by children or individuals that are untrained

or incapable of understanding these safety precautions!

2. Do not reach into the feed opening for any reason! Never insert fingers, hands, other

extremities, or objects not meant to be shredded into the feed opening!

3. Do not operate or come in close proximity to this equipment wearing long hair,

necktie, loose clothing, or jewelry which may activate a photoelectric on/off switch

and/or be pulled into the shredder.

4. Maintenance or repair of this equipment should be performed only be trained,

authorized service personnel.

5. Always disconnect electrical power (unplug) before removing or opening the cover or

other panels providing access to internal mechanisms.

SPECIFICATIONS

Shred Size 2.2 mm x 4 mm

Dimensions 40.25”H x 21.5”W x 23.25”D

Weight 260 lbs.

Cutting Power up to 1600 pieces/hr. CD’s or DVDs * IMPORTANT see below

*Important: This machine is to be used for CD’s or DVDs only, not paper. If used for paper warranty may be voided.

Note: For 115V/1/60Hz units a 20 amp line is required. For best results this line should not be more than 50 feet from the

circuit breaker panel.

For NATIONWIDE SERVICE Call 1(800)225-9293

2

Table of Contents

READ CAREFULLY BEFORE USING

Proper care of your new CD/DVD shredder will ensure many years of trouble free operation, with minimum of

maintenance or repair.

IMPORTANT: Please note that all packaging should be retained by the customer for (30) days from the

time of receipt. In the event that this unit needs to be sent back for replacement or repair this packaging

will be required to do so. Should the packaging have been discarded before the (30) day requested

period, packaging costs will be incurred by the customer.

Contents Page No.

Safety Procedures…………………………………………………………………………………………..2

Table of Contents…………………………………………………………………………………………..3

Safety Precautions………………………………………………………………………………………..4-6

Installation and Set-up………….…………………………………………………………………..............7

Operation and Feeding …………………………………………………………………………….…....8-11

Troubleshooting.…………………………………..…………………………………………………...12-15

Accessories..............……………………………………………………………………………………….16

Technical Information……………………………………………………………………………………..17

Spare Parts List ………………………………………………………………………………………...18-23

Wiring Diagram………………………………………………………………………………………...24-26

Customer Service

Security Engineered Machinery Co., Inc.

PO Box 1045

5 Walkup Drive

Westboro, MA 01581

Tel: 800-225-9293 Fax: 508-366-6814

Website: www.semshred.com

E-mail: [email protected]

Order On-line:

GSA Customers: www.fedshred.com

Commercial Customers: www.semshred.com

IMPORTANT

Two to three preventive maintenance calls per year are recommended

Only authorized SEM service personnel should be allowed to service the shredder.

For NATIONWIDE SERVICE Call 1(800)225-9293

3

SAFETY PRECAUTIONS

The door must be closed when operating the

shredder.

Ensure free access to mains.

Automatic standby that switches off after 1 hour;

green LED control light is off.

For NATIONWIDE SERVICE Call 1(800)225-9293

4

SAFETY PRECATIONS Cont…

Remove plug before cleaning the machine.

Do not operate the machine without the safety flap (A).

ON/OFF! Quick stop’! Open the door!

For NATIONWIDE SERVICE Call 1(800)225-9293

5

SAFETY PRECATIONS Cont…

Destroyed CD/DVD material must not be emptied

onto the floor. Danger of slipping!

For NATIONWIDE SERVICE Call 1(800)225-9293

6

INSTALLATION

Installing the oiler:

• Take the oiler holder out of the cabinet and

hook it into the side of the cabinet (A).

• Remove the lid from the oil bottle (B)

• Put the oil tube into the oil bottle and screw on (C)

• Click the tube into the connection (D)

Insert the plastic bag in the container.

Note: Must use SEM proprietary Anti Static

Bag #638ASB0201. If not used static will affect

machines performance and may void warranty.

Close the door; Plug into wall socket.

For NATIONWIDE SERVICE Call 1(800)225-9293

7

OPERATION

When Using for the first time the oil pump starts

automatically:

•Press after approximately 30 seconds red blinking

LED (A) disappears.

When the oil bottle (B) is changed:

•Press the rocker switch “R” until the red LED

(A) no longer blinks red.

Flashing LED (A):

•Cutting shafts are automatically oiled.

Warning:

Materials other than CD’s or DVDs may jam and /or

damage the cutting unit. Shredding Paper may void

Warranty. NO PAPER!

For NATIONWIDE SERVICE Call 1(800)225-9293

8

OPERATION Cont….

•Press the rocker switch (1.): green light is on,

The machine is now ready for operation.

•Machine starts automatically when CD/DVD is inserted.

(Note: The machine will automatically switch off after

one hour and the green LED control light will turn off.)

•When the machine is switched off continuous operation

can be switched on. Press or hold until the machine

starts. To switch off the continuous operation press or

hold or “R”

Note: Feed one CD or DVD at a time only,

through small slot only as shown in (2.)

LED shows red (A).

Stops automatically if too many CD/DVDs are

inserted.

LED shows yellow (B).

Maximum CD/DVDs capacity during shredding

process.

LED Shows green (C).

Normal CD/DVDs capacity during shredding

process.

Important: Between CD/DVDs insertion allow the

machine to return to the LED green light. (C) If you

insert CD/DVDs while the LED yellow light (B) is lit you

may cause a jam, (See page 11 for jams).

Stops automatically when no further CD/DVDs are

inserted.

By continuous operation press or “R” switch off.

For NATIONWIDE SERVICE Call 1(800)225-9293

9

OPERATION Cont….

Stops automatically when door is opened

symbols and flash alternatively.

Stops automatically when plastic bag is full.

Enough (half full, because of weight, otherwise it is too

heavy to be transported)

The “bag full” indicator lights.

Stops automatically if too many CD/DVDs are inserted.

Automatic reverse if CD/DVDs jam.

(Symbol “ON/OFF” flashes).

For NATIONWIDE SERVICE Call 1 (800)225-9293

10

OPERATION Cont….

If required: (Jam)

Open the safety flap (1.)

Remove CD/DVD (2.)

Reset by pressing the rocker switch . Re-feed the

CD/DVD.

For NATIONWIDE SERVICE Call 1(800)225-9293

11

TROUBLESHOOTING

Machine will not start.

Is the machine plugged in?

Is the rocker switch pressed?

Is the green light rocker switch ON? (1)

Feed only one CD/DVD at a time into the

opening (2).

For NATIONWIDE SERVICE Call 1(800)225-9293

12

TROUBLESHOOTING Cont….

Feed the CD/DVD into the center of the feed opening.

(photo cell) (A)

Is the door open?

Is the container half full?

Note: Container will not fill all the way

this is a factory setting. If filled completely

then container would be to heavy.

For NATIONWIDE SERVICE Call 1(800)225-9293

13

TROUBLESHOOTING Cont….

Machine will not stop.

Unplug from the main. Clean the photo cell (A)

with a small brush or Q-tip with isopropyl

(rubbing alcohol)

By continuous operation press or “R” switch off.

Machine stops.

Symbols and “R” flash alternatively.

• Overload protection. Cooling down period

approximately 10-15 minutes.

• Symbol lights green, machine is ready

for operation.

Container “indicator illuminates but bag is not

half full.

• Remove container (A)

• Clean the level sensor with a brush (B) or

Q-tip with isopropyl (rubbing alcohol)

For NATIONWIDE SERVICE Call 1(800)225-9293

14

TROUBLESHOOTING Cont….

None of the above mentioned methods helped

To solve the problem:

Contact our Customer Service at 1(800)225-9293

For NATIONWIDE SERVICE Call 1(800)225-9293

15

ACCESSSORIES

Environmentally friendly oil (4 gallons)

Part # 647OILHV

Proprietary Anti-Static

Plastic Bags (50 pieces)

Part # 638ASB0201

For NATIONWIDE SERVICE Call 1(800)225-9293

16

TECHNICAL INFORMATION

Do not shred paper clips.

Do not destroy Paper.

This machine is approved by independent safety

laboratories and is in compliance with the EC-regulations

98/37/EG, 2006/95/EG and 2004/108/EG.

Since 1/29/09 will be replaced by 2006/42/EG

from12/29/2009

Sound Level Information:

The sound level at the work place is less than the ISO 7779

standard’ maximum permissible level of<70 db (A).

The exact technical specifications can be found on the

technical specifications sticker on the machine.

To claim under guarantee, the machine must still carry its

original identification label.

Subject to alterations without notice.

For NATIONWIDE SERVICE Call 1(800)225-9293

17

Parts List

For NATIONWIDE SERVICE Call 1(800)225-9293

18

Parts List Cont….

For NATIONWIDE SERVICE Call 1(800)225-9293

19

Parts List Cont….

For NATIONWIDE SERVICE Call 1(800)225-9293

20

Page is loading ...

SEM 0201 OMD Operating instructions

SEM 0201 OMD Operating instructions

Related papers

Other documents