GE GFP1528PNDG User manual

Type
User manual
KIT CONTAINS
If you have any questions, call GE Appliances at 800.GE.CARES
(800.432.2737)
or visit our Website at: GEAppliances.com
In Canada, call 800.561.3344
or visit GEAppliances.ca
Pedestal Kit
GFP1528
Installation
Instructions
31-3000210 Rev. 1 08-19 GEA
TOOLS YOU WILL NEED
Safety Glasses
1/4" Socket & Nut Driver
5/8" Open end wrench
Gloves
Level
Rear
Rear
Front
Front
IMPORTANT: Shipping bolts should remain in
place during installation.
Washer/Dryer Brackets - 2 each
Pedestal
Installation Screws
(#8-18 x 7/16) - 22
Pedestal Brackets - 2 each
Drawer Divider
2 31-3000210 Rev. 1
Installation Instructions
1
INSTALL REAR PEDESTAL BRACKETS
FOR DRYER AND 32" WASHER
Align rear pedestal bracket as shown on both sides.
FOR 34" WASHER
Install bracket rotated 180° from dryer configuration.
2
INSTALL FRONT PEDESTAL
BRACKETS
Install front pedestal brackets on both sides.
PREPARE THE PEDESTAL
31-3000210 Rev. 1 3
Installation Instructions
3
INSTALL WASHER/DRYER
BRACKETS
Front Brackets
Ŷ/D\WKHXQLWRQLWVEDFNRQDSURWHFWLYHVXUIDFH
Ŷ(QVXUHOHYHOLQJOHJVDUHWKUHDGHGLQWR
minimum height position.
Ŷ,QVWDOOIURQWEUDFNHWVRQWKHERWWRPRIWKH
washer or dryer as shown. Use the 2 holes
closest to the front and the 2 outermost holes
on the bracket. The bracket should not go
beyond the edge of the appliance.
Rear Brackets
Ŷ,QVWDOOUHDUEUDFNHWVRQWKHERWWRPRIWKH
washer or dryer as shown above. Use the top
2 holes on the bottom of the appliance with the
tab on the bracket facing the outside.
PREPARE THE UNIT
4
JOIN REAR BRACKETS
Ŷ/LIWSHGHVWDODQGKRRNIURQWEUDFNHWVRISHGHVWDO
to front brackets of washer or dryer.
Ŷ$OLJQUHDUEUDFNHWVRQZDVKHURUGU\HUZLWKUHDU
brackets on pedestal and fasten with screws.
Make sure the bracket from the appliance is to
the INSIDE of the pedestal bracket and not the
outside.
ATTACH PEDESTAL TO
UNIT
Front Brackets
Rear Brackets
J
4 31-3000210 Rev. 1
Installation Instructions
6
JOIN FRONT BRACKETS
Ŷ)DVWHQVFUHZEHWZHHQIURQWEUDFNHWVIRU
pedestal and washer or dryer on both sides of
unit.
7
WASHING MACHINE ONLY:
REMOVE SHIPPING SCREWS
Remove the 4 shipping bolts on the back side of
the unit.
8
FINALIZE THE INSTALLATION
Refer to the washer or dryer installation
instructions to complete the installation.
ATTACH PEDESTAL TO UNIT (cont.)
5
LEVEL THE WASHER OR DRYER
Ŷ/RFDWHWKHOHJVIURPWKHSDUWVSDFNDJHDQG
install to minimum height.
Ŷ6WDQGWKHZDVKHURUGU\HUXSULJKW
Ŷ0DNHVXUHWKDWWKHZDVKHURUGU\HULVOHYHOE\
placing a spirit level on top. Check side to side
and front to back.
Ŷ8VHDRSHQ
ended wrench to
adjust the legs in
and out. Tighten
the lock nut
against the bottom
of the pedestal.
NOTE: To minimize
vibration, the locking
nuts must be tight.
Printed in Taiwan
2 31-3000210 Rev. 1
Instructions d’installation
1
INSTALLER LES SUPPORTS DE PIÉDESTAL ARRIÈRE
POUR SÉCHEUSE ET LAVEUSE 32 PO
Alignez le support de piédestal arrière sur les deux
côtés comme illustré.
POUR LAVEUSE 34 PO
Installez le support tourné à 180° de la disposition
de la sécheuse.
2
INSTALLER LES SUPPORTS DE
PIÉDESTAL AVANT
Installez les supports de piédestal avant sur les
deux côtés.
PRÉPARER LE PIÉDESTAL
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12

GE GFP1528PNDG User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI