ARTIVA AF20203BG Installation guide

Type
Installation guide
!
WARNING
1.This product contains bolts and other small parts that may present a chocking hazard for children 3 years or
under.This unit must be assembled by an adult.
2.periodically check the safety of your product by making certain all bolts and nuts are tightened securely.
CAUTION
Place the back frame(A) on the base(B) and align the
holes in the back frame(A) with the holes on the
base(B).Use the screw (H) in each of the two holes as
shown and tighten with allen key (I),Put (K) into the
seat top.
H
K
A
B
A
B
C
D
E
F
1pc 1pc 2pcs
2pcs 1pc 1pc
COMPONENT PARTS
Back Frame
Base armrests
Back Cushion
Seat Cushion
H I
G
K
2pcs 2pcs
2pcs 2pcs
30mm SCREWS AND
WASHERS
PARTS LIST
ALLEN KEY
Armrest
Cushions
METAL PLUGS
METAL ROD
STEP 1
NOTE:
DO NOT TIGHTEN SCREWS
UNTIL STEP 3.
Page 2-1
ASSEMBLY INSTRUCTIONS
Glider/Rocker with Ottoman
ITEM#:AF20203-MSR
J
WOODEN
PLUGS
2pcs
L
45mm SCREWS AND
WASHERS
2pcs
STEP 2
STEP 3 STEP 4
Attach the back cushion(E)
to the back frame(A).
Attach the seat cushion(F).
Attach the armrest cushions(D)
to the armrest(C) by the velcro
along the interior seat and on
the sides.
STEP 5 STEP 6
C
J
E
F
Use (I) tighten (J) Also tighten (L) Which
connect armrest(C) and back frame(A).
Cover the hole via wooden plugs(G) onto
back frame(A).
NOTE:
DO NOT TIGHTEN SCREWS
UNTIL STEP 3.
Page 2-2
STEP 7
L
Tie up the cushion onto
backrest
G
D
  • Page 1 1
  • Page 2 2

ARTIVA AF20203BG Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI