York Mini VRF Heat Pump Outdoor Unit Single Phase 208/230V Installation guide

York
Brand
York
Model
Mini VRF Heat Pump Outdoor Unit Single Phase 208/230V
Type
Installation guide
Model: WSP-160A
This Wind Guard is to protect the outdoor unit from strong winds. For correct performance, be sure to read
this manual carefully before installation work.
IMPORTANT NOTICE:
 Johnson Controls pursues a policy of continuous improvement in design and performance of products. We
UHVHUYHWKHULJKWWRYDU\VSHFL¿FDWLRQVZLWKRXWQRWLFH
 No part of this manual may be reproduced without Johnson Controls’ written permission.
 Keep this manual for future reference.
 Johnson Controls cannot anticipate every possible circumstance that might involve a potential hazard.
 This kit is designed for a combination of Johnson Control air conditioners. Do not use this kit by itself or in
combination with other companies’ air conditioners.
 Perform a test run after installation to check for abnormalities.
 6LJQDOZRUGVDUHXVHGWRLGHQWLI\OHYHOVRIKD]DUGVHULRXVQHVV'H¿QLWLRQVIRULGHQWLI\LQJKD]DUGOHYHOVDUH
provided below with their respective signal words.
Installation Manual for Wind Guard (for Outdoor Unit)
: Indicates a hazardous situation that, if not avoided,
could result in death or serious injury.
: Indicates a hazardous situation that, if not avoided,
could result in minor or moderate injury.
1. Applicable Unit
NOTE
:
7KHDSSOLFDEOHRXWGRRUXQLWPD\EHGLIIHUHQWGHSHQGLQJRQWKHSURGXFWVHULHV%HVXUHWRFRQ¿UPZLWK
the product catalogue before installation.
Name Wind Guard
Model WSP-160A
Applicable Outdoor Unit
Side Flow Type
36,000 to 60,000 Btu/h
2. Cautions for Installation
(1) If the outdoor unit is installed in a snow covered area, install a Snow Protection Hood (other optional
parts).
 7KHDLURXWOHWVLGHRIWKH:LQG*XDUGVKRXOGEHRSHQ,IVRPHREVWDFOHVH[LVWLWPD\EORFNDLUÀRZRU
FDXVHLQVXI¿FLHQWDLUÀRZ
(3) Do not install other outdoor units in the air outlet direction. Other outdoor units will intake the outlet air
from the Wind Guard.
(4) The operation noise may be slightly increased due to the Wind Guard installation.
(5) In case of icing at the air outlet part, use lukewarm water (approx. 104
o
F (40
o
C)) for melting.
The Wind Guard may be damaged when using objects or tools to break the ice.
1
3. Service Space
Service space for the Wind Guard installation is as shown below.
(1) Both sides of the outdoor unit should be open.
(2) No obstacles should exist in the air outlet side.
Wind Guard
Min.7-7/8 inch (200mm)
Outdoor Unit
Passage Side
Unit: inch (mm)
No. Accessory
Qty.
WSP-160A
1
Wind Guard (Upper)
28-5/8
(727)
24-13/16
(630)
10-13/16
(275)
1
2
Wind Guard (Lower)
10-13/16
(275)
24-3/4
(628)
26-13/16
(681)
1
3
Securing Stay
23-7/16
(596)
9/16
(15)
1
4
Securing Screw
1/2
(12)
M5 (with Washer)
14
4. Before Installation
Check that all the following accessories are packed with the unit before installation.
2
$IWHUFRQ¿UPLQJWKHRXWGRRUXQLWPRGHOLQVWDOOWKH:LQG*XDUGDFFRUGLQJWRWKHIROORZLQJSURFHGXUHV
(1) Attach the securing stay
3
into the two installation holes between the upper and lower air outlet grille
with two securing screws
4
(accessories).
(2) Remove the securing screws at the under side of the air outlet grille (lower) (3 places), then secure the
Wind Guard (lower)
2
to the outdoor unit and the securing stay
3
with two securing screws
4
.
(3) Remove the securing screws at the upper side of the air outlet grille (upper) (3 places), then secure the
Wind Guard (upper)
1
to the outdoor unit and the Wind Guard (lower)
2
with four securing screws
4
.
5. Installation Procedures
Do not remove the air outlet grille for the Wind Guard installation. If the Wind Guard is
installed without an air outlet grille, injury may be caused by fan rotation.
4
3
3
A
ir Outlet Grille
(Lower)
4
2
4
4
A
ir Outlet Grille
(Upper)
1
2
4
3
6. Installation Appearance
10-13/16
(275)
Air Outlet Grille (Upper)
Wind Guard (Upper)
Wind Guard (Lower)
Securing Stay
Outdoor Unit
Air Outlet Grille (Lower)
Securing Screws (2 x 2 x M5)
(Accessory)
Securing Screws (3 x M5)
(Accessory)
Securing Screws (3 x M5)
(Accessory)
© 2016 Johnson Controls, Inc.
Code No. LIT-12012281
Issued March, 2016
P5416654
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

York Mini VRF Heat Pump Outdoor Unit Single Phase 208/230V Installation guide

York
Brand
York
Model
Mini VRF Heat Pump Outdoor Unit Single Phase 208/230V
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents