2. Ideal
  3. WireTwist® Wire Connector, Model WT1 Gray
WireTwist® Wire Connector, Model WT1 Gray

Ideal WireTwist® Wire Connector, Model WT1 Gray, WireTwist® Wire Connector, Model WT2 Blue, WireTwist® Wire Connector, Model WT3 Orange, WireTwist® Wire Connector, Model WT4 Yellow, WireTwist® Wire Connector, Model WT6 Red, WireTwist™ Wire Connector, Model WT3 Orange, Barrel of 50,000, WT1 Gray, WT2 Blue, WT3 Orange, WT4 Yellow, WT6 Red Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Ideal WireTwist® Wire Connector, Model WT1 Gray Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
7-19-2016
WireTwist™ Wire Connector Instructions
WARNING:
Improper use or installation of this product may cause fire, electrocution, serious personal injury or death. Shut off power to the
circuit or remove fuse before using this product. Use only connectors properly sized to the wires being used. Consult local building
codes for installation requirements.
To be sold only with instructions.
Installation Instructions
1. Turn off power before removing or installing connectors.
2. Strip connectors to the correct strip length per the chart below:
Connector
Strip length
WT1*
Strip solid wires ¼” (6mm)
Strip stranded wires 5/16” (8mm)
WT2*
Strip wires 3/8” (9.5 mm)
Strip wires #16 and smaller ½”
(13mm)
WT3**
Strip wires 5/16” (8mm)
Strip wires #16 and smaller strip 3/8” (9.5 mm)
WT4**
Strip wires 3/8” (9.5 mm)
Strip #16 and smaller 7/16” (11 mm)
WT6**
Strip wires #14 and larger 7/16” (11 mm)
Strip wires #16 and smaller ½”
(13mm)
3. Straighten and align frayed strands.
4. Hold wires together with ends even. Lead stranded wires slightly ahead of solid wires.
5. Pre-twisting acceptable, but not required. For pre-twisting; strip wires long, hold wires together with insulation even, twist
wire ends together, trim to recommended strip length.
6. Insert bundle into connector and twist clockwise until tight.
Use only on Copper to Copper (Cu/Cu) wire combinations.
For use in dry locations only.
Temperature rating: 105
◦
C (221
◦
F) maximum.
*300 volts maximum; 1000 volts signs or lighting fixtures.
**600 volts maximum building wire; 1000 volts signs or lighting
fixtures.
UL 486C Listed and CSA C22.2 #188 Certified
Complies with Federal Specification W-S-61D
/