Light Kit Installation
41528-01 6/17/2005
A-19
60 W Max
x 3
41528-01.indd 6/17/2005, 9:07 AM1
2
1
1-1
1-2
2
3
4
Remove lower housing.
Remove plug and cap.
Remove plate.
Partially reinstall screws.
1
2
3
4
41528-01.indd 6/17/2005, 9:07 AM2
Unscrew finial.
Engage keyholes, tighten screws.
Replace finial.
Remove rings.
5
6
7
8
6-1
6-2
5
7
8
41528-01.indd 6/17/2005, 9:07 AM3
99
11-1
11-2
12
10
Connect plugs.
Reinstall screws.
Install glass.
Install bulbs.
12
11
10
9
1
2
41528-01.indd 6/17/2005, 9:07 AM4
READ ENTIRE TEXT CAREFULLY BEFORE BEGINNING INSTALLATION AND SAVE THESE INSTRUCTIONS.
WARNING!
• To reduce the risk of electrical shock and re, install this light kit only on Hunter suspended ceiling fans.
• To avoid possible electrical shock, before installing light xtures, disconnect power by turning off the circuit
breakers both to the outlet box and to its associated wall switch location. If you cannot lock the circuit
breakers in the off position, securely fasten a prominent warning device, such as a tag, to the service panel.
• Connect house wiring to the fan before attaching the light xture to the fan.
• All wiring must be in accordance with national and local electrical codes. If you are unfamiliar with wiring,
you should use a qualied electrician. Professional installation is recommended.
• Suitable for indoors at 40
o
C.
NOTE: WHEN REPLACING BULBS, REPLACE WITH TYPE A-19 (MAX 60W).
41528-01.indd 6/17/2005, 9:07 AM5
Hunter Fan Company 2500 Frisco Avenue Memphis, TN 38114 USA
www.hunterfanglobal.com
2
1
Troubleshooting
Problem:
Nothing happens, light does not come on.
Problem:
Glass rattles.
Solution:
1. Restore power to the fan.
2. Pull light chain one or two times.
3. Make sure bulbs are properly installed
and lament is not blown.
4. Make sure plug connectors are properly
connected and locked together.
5. Check light power lead at the ceiling.
6. Contact your local Hunter dealer.
Solution:
1. Tighten rings.
2. Reposition arms.
3. Contact your local Hunter dealer.
41528-01.indd 6/17/2005, 9:07 AM6
/
