Hampton Bay 79718 Installation guide

Type
Installation guide
1
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
A B C D E
F
G
H
I
J
PACKAGE CONTENTS
PLANNING FOR A SUCCESSFUL ASSEMBLY
Read all instructions before assembly and installation.
Inspect each part for defects that may have occurred during shipping.
Keep your receipt and these instructions for proof of purchase.
CHOOSING THE RIGHT LOCATION
Install your solar light in a location with full, direct sunlight. Do not install in shad-
ed areas as these areas will not allow the batteries to fully charge and reduce
the nighttime operating hours for your light. Ensure that the installation location
is away from other nighttime light sources such as street or porch lamps. These
light sources may prevent your solar light from automatically turning on.
Part Description Quantity
A Spotlight head 3
B Fixers 3
C Screws 6
D Spotlight stake 3
E Solar panel 1
F Battery cover 1
G Waterproof cover 1
H
450mAh LiFePO4, 14430 3.2V
rechargeable battery (pre-installed)
3
I Post for solar panel 1
J Solar panel stake 1
HOW SOLAR WORKS
The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries.
At night, the solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location,
daily weather conditions, and season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.
Assembly and Installation
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
NOTE: Do not use a hammer. If the ground is
hard, use water to soften or a trowel to loosen
the soil.
NOTE: Ensure the wire at the bottom of the
spotlight head ts into the notch (AA) at the
bottom of the spotlight head post to avoid
pinching the wire.
Attaching and installing the
solar panel and stake
Installing the spotlight
into the ground (Option 1)
Insert the post (I) into the bottom of the solar
panel (E).
Insert the solar panel stake (J) rmly into the
solar panel post (I).
Push the assembly into the ground.
Attach the spotlight head (A) rmly to the stake
(D).
Push the spotlight assembly rmly into the
ground.
1 2
E
I
J
A
AA
D
Solar LED Spotlights with Remote
Solar Panel
Use and Care Guide
Item #555-208
Model #79718
NOTE: Make sure the wire at the bottom of
the spotlight head ts into the notch (AA)
at the bottom of the spotlight head post to
avoid pinching the wire.
Installing on a wooden post
(Option 2)
Mount the xer (B) to the post using the
screws provided (C).
Attach the spotlight head (A) rmly to the
xer (B).
2
A
C
AA
B
2
Maintenance
Care & Cleaning
Troubleshooting
Warranty
Replacing the batteries
1
CAUTION: When replacing the batteries, use three (3) 450
mAh LiFePO4, 14430 3.2V rechargeable batteries.
IMPORTANT: Dispose of the batteries in accordance with
local, state, and federal regulations.
Remove the battery cover (F) and then the waterproof cover (G) from the solar panel (E).
Replace the old batteries with fresh 450 mAh LiFePO4, 14430 3.2V rechargeable batteries (H).
Replace the waterproof cover (G) and then the battery cover (F) onto the solar panel (E).
Clean the solar panel with a damp cloth. Do not use any chemicals or abrasives.
G
H
H
E
F
Problem Solution
The nightly runtime for the lights is shorter. The battery is not adequately charged. Locate the solar light in an area where it can receive the maxi-
mum amount of full, direct sunlight every day.
The batteries are reaching the end of their useful life. Replace the old batteries with new batteries.
The lights do not turn on in the evening. The solar panel is installed close to other light sources. Relocate the solar panel or eliminate the other
light sources.
The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only
to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation,
and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through
misuse, abuse, accident, modications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly
installed, set up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as
a result of an accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty workmanship. This warranty shall not
apply to the nish on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant
and specically disclaims any warranty, whether expressed or implied, or tness for a particular purpose, other than the warranty contained herein. The manufac-
turer specically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the
replacement or repair of said product.
Contact the Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
Assembly and Installation (continued)
NOTE: Each spotlight has a top wire (1) and a bottom wire
(2).
Connecting the spotlights
Connecting the spotlights to the solar
panel
Connect the spotlights in a series by screwing the bottom wire (2)
clockwise into the top wire (1) of the next light.
Connect the last spotlight in the series to the solar panel (E) by
screwing the bottom wire (1) clockwise into the outlet plug on the
underside of the solar panel (2).
3 4
2
1
E
2
1
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Hampton Bay 79718 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI