Atlas Metal Industries WB-15 Datasheet

Brand
Atlas Metal Industries
Model
WB-15
Type
Datasheet

This manual is also suitable for

a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
SPECIAL APPLICATION DROP-INS
ICE CHEST
Non-Mechanical
Item No.
Quantity
WB-15
WB-19
DESCRIPTION:
The WB series ice chests make it possible to
put large capacity ice storage directly in your
serving line. The convenience of a removable
hinged lid is included. Maximize your efficiency
- put ice service where you need it most.
The ice chest is fully insulated and provided
with a factory applied gasket so that it can be
installed in the finest wood fixtures without
marring the counter top. The unit is constructed
of stainless steel and is provided with a 1” IPS
drain.
FEATURES:
Fully insulated to hold ice longer
Factory applied gasket - makes installation
a snap and seals units to the counter top,
thus eliminating seepage
NSF certified
SA-3
WB-15 SHOWN
a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
ICE CHEST
Non-Mechanical
MODEL
WB-15
WB-19
SHIP WT.
(
lbs.)
34
55
40
60
13-1/2” X 17-1/4”
17-1/4” X 22-1/4”
CUT-OUT
REQUIRED
ICE CAPACITY
(lbs.)
TOP: Constructed of 18 gauge, type 304 stainless
steel, die stamped with a raised perimeter bead.
There shall be a solid vinyl gasket under the beaded
edge to form a seal to the counter top, thus prevent-
ing seepage or marring of the counter top.
ICE CHEST: The inner liner shall be 22 gauge, type
304 stainless steel. All corners are coved with a min-
imum 1/4” radius. A 1” dia. threaded drain fitting is
provided.
INSULATION: The pan is fully insulated with high
SPECIFICATIONS:
density polystyrene, 1” thick on all sides, 1-1/2” thick
on the bottom and enclosed with a 24 gauge galva-
nized steel outer liner. The entire unit is removable
without the use of tools.
LID: The ice chest is provided with a double pan,
insulated lid with a rubber, self-insulating hinge. The
entire lid is removable.
Specifications subject to change without notice.
SA-4
10/07-SC
24”
6 1/2”
11”
6 1/2”
15”19”
WB-19 Shown
Plan View
8 1/2”
14 1/4”
3 1/4”
22”
8 1/2”
8 1/2”
17 1/2”
Elevation
End View
1”IPS Drain
13 1/4”
6 5/8”
6 5/8”
17”
3 1/4”
1”IPS Drain
End View
Elevation
14 1/4”
8 1/2”
WB-15 Shown
Plan View
2”
15”
19”
2”
11”
15 1/4”
2 1/8”
2 1/8”
  • Page 1 1
  • Page 2 2

Atlas Metal Industries WB-15 Datasheet

Brand
Atlas Metal Industries
Model
WB-15
Type
Datasheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers