a subsidiary of Mercury Aircraft
1135 NW 159 Dr., Miami, Florida 33169
Tel: (305) 625-2451 or (800) 762-7565 • Fax: (305) 623-0475
BIFD
BUILT-IN FREEZER DISPENSER W/ CONDENSING UNIT
Project Name
N
O
# Item N
O
# Quantity
SPECIFICATIONS
CONSTRUCTION:
Shall have heavy-duty galvanized outer casing,
with stainless steel inner liner and 1” l.P.S. drain,
separated by high efficiency polyurethane
foamed in-place insulation, high impact plastic
breaker strip and raised edge throat liner. The
cabinet and condensing unit is supported by an
all welded galvanized angle frame.
REFRIGERATION:
Thecabinet shall have copper coils soldered to the
outside of the inner liner, on three sides, opposite
the condensing unit. Condensing unit shall be low
temp, pressure controlled 120v/6Ocy/1 phase, her-
metically sealed, to power the system, and use
134-A refrigerant. A 6’ 3 wire power cord and plug,
NEMA-5-15P, shall be provided.
LIDS:
Shall be hinged, folding type, with stainless steel
outer shell, high impact plastic underliner, and
foamed in-place insulation.
SELF-LEVELING:
Elevators shall be die stamped telescoping tub-
ing, non-fatiguing compression type springs, all
stainless steel, completely enclosed.
BUILT-IN FREEZER DISPENSER
FOR HIGH VOLUME LIMITED SPACE
APPLICATIONS
OPTIONS AND ACCESORIES
Plexiglas lids
Lid locking device
220V / 50 cycle compressor
5-year compressor warranty
Special height
“ALL PRICES AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE”
51