I
f
Y
READ AND UNDERSTANDTHESEINSTRUCTIONSBEFOREINSTALLINGFIXTURE
INSTRUCTION SHEET NO,
This fixture is intendedfor installationin accordancewith the NationalElectricalCode and local
regulations.Toassurefullcompliancewithlocalcodesandregulations,checkwithyourlocal
electrical
inspector before installation. To prevent electrical shock, turnoff electricity at fuse box before proceeding.
IS:6087
Retain these instructions for maintenance reference.
R0493
Page 1 of 1
T-BAR RUNNER MOUNTING CLIPS
FOR USE WITH BASIC OR ADVENT LYTESPAN” TRACK SYSTEM ONLY
15/16”OR9/16”ATFACE OFT-BARRUNNER
SQUARE EDGE
REGRESSED
CEILING PANEL
EDGECEILING PANEL
3“” L
‘Iv
6089
!
MOUNTINGCLIP
Ifi ~
6087
TRACKUNIT
MOUNTINGCLIP
TRACKUNIT
SQUAREEDGEPANEL
REGRESSED EDGE PANEL
NOTE: Track can be positioned at any angle relative of the T-BAR.
1. Use2MOUNTlNG CLlPSfor2’and 4’track units. Use3MOUNTlNG CLlPSfor8’track unit.
2. Rotate MOUNTING CLIP onto T-BAR, See Fig, 1,
3. Rotate the white portionof the MOUNTING CLIP to initial positionand rotate intoTrack Unit. See Fig. 2.
T-BAR
INITIAL POSITION
ROTATE CLIP
CLOCKWISE
WHITE PORTION
OF CLIP
FIG. 1
—
CLIP FOR
4
OUTLET BOX
OPENING
NOTE: (4)CLIPS ARE ONLY USED
ON OUTLET BOX FOR GRID
CEILING CANOPY KIT 6096WH
WHEN NECESSARY
FIG. 2
1-M <5
l-m-c>1-1E R“
ERWR<!RK:ZR
/
