MRHANDSFREE iBell set KB300 User manual

Brand
MRHANDSFREE
Model
iBell set KB300
Type
User manual

This manual is also suitable for

User’s Manual
GB
NL
FR
D
ILLUSTRATIONS
DECLARATION OF CONFORMITY
GB
CONTENT OF PACKAGING
Kinec Doorbell buon + 230V Receiver + Mobile Receiver + 3M Industrial tape
PARTS & BUTTONS
Kinec Doorbell buon
A: Doorbell buon
INSTALLING AND PAIRING THE KINETIC DOORBELL BUTTON
You can aach the Kinec Doorbell Buon to any surface using the 3M Industrial tape or screw it into
the wall. Remove the back part of the Doorbell Buon and mount 2 screws into the foreseen area to
open the plasc. Hold the back part against the wall you wish to aach it to and, by using a pencil,
indicate where you need to drill the holes. Remove the back part and drill 2 holes where the indicaon
is visible. Insert 2 plugs into the holes, hold the back part over and screw it in place. To nish, place the
front of the Doorbell buon on the back part unl it clicks in place.
You can pair mulple (oponally available on www.mrhandsfree.com) with the receivers. Simply press
the Tone-Selecon (C, G) on the 230 Receiver or the Mobile receiver for 5 seconds unl you hear a
sound nocaon. Press the doorbell-buon (A) and you will hear another sound nocaon. Aer 10
seconds, you will hear another sound nocaon. Your devices are now paired.
INSTALLING AND PAIRING THE 230V RECEIVER
You can plug the 230V receiver into any plug desired in your house, the pairing for your set has already
been done during producon.
To pair an extra 230V receiver with your doorbell buon (oponally available on www.mrhandsfree.com),
press the Tone Selecon buon (C) for 5 seconds unl you hear a sound nocaon. Press the Kinec
Doorbell Buon (A) and you will hear another sound nocaon. Aer 10 seconds, you will hear
another sound nocaon. Your devices are now paired.
INSTALLING AND PAIRING THE MOBILE RECEIVER
Before installing the Mobile receiver, insert 3x AA Alkaline baeries into the Baery Compartment (F).
Press it lightly and slide it down to open the compartment. Insert 3 AA Alkaline baeries according to
the visible scheme and close the lid again by sliding it in place unl you hear a click. You can put and
take the Mobile receiver anywhere in your house (up to 150m), the pairing for your set has already
been done during producon.
To pair an extra Mobile receiver with your doorbell buon (oponally available on www.mrhandsfree.com),
press the Tone Selecon Buon (G) for 5 seconds unl you hear a sound nocaon. Press the kinec
doorbell buon (A) and you will hear another sound nocaon. Aer 10 seconds, you will hear
another sound nocaon. Your devices are now paired.
SELECTING A RINGTONE AND ADJUSTING THE VOLUME
To select a ringtone on either the 230V receiver or the Mobile receiver, press the Tone selecon buon
of the device (C, G) unl you hear the ringtone you wish to select.
Note: If you wish to have the same ringtone on both devices, you have to set it for each device separately.
Note: When mulple Kinec Doorbell Buons are paired to your device, it is not possible to have a
separate sound for each doorbell buon.
To adjust the volume on either the 230V receiver or the Mobile receiver, rst, press the Tone selecon
buon of the device (C, G) to hear a tune and press the Volume buon of the device (D, H) to select
the desired volume.
SUPPORT
For more informaon, technical quesons and return requests concerning this product, you should
contact support@mrhandsfree.com.
WARRANTY
Mr Handsfree is a registered trademark of TE-Group NV. The mr Handsfree brand stands for superior
product quality and outstanding customer service. That is why mr Handsfree warrants this product
against all defects in material and workmanship for a period of two (2) years from the date of original
purchase of the product. The condions of this guarantee and the extent of responsibility of mr
Handsfree under this guarantee can be downloaded from our website: www.mrhandsfree.com.
230V Receiver
B: Power Plug
C: Tone selecon-buon
D: Volume
Mobile Receiver
E: ON / OFF switch
F: Baery Compartment
G: Tone selecon-buon
H: Volume
WIRELESS DOORBELL SET
Hereby, Par la présente,
Company:
Entreprise:
Address:
Adresse:
declare that the following equipment: déclare que le disposif suivant :
Product name: Nom du produit:
Product type: Type de produit:
Joseph van Oosterum, CEO TE-Group NV
Authorised signature
TE-Group NV
Kapelsestraat 61, 2950 Kapellen, Belgium
mr. Handsfree i-Bell Set KB300
Wireless Kinec Doorbell & Receivers
2011/65/EC, 2014/30/EC & 2014/35/EC. Conformity is guaranteed by the CE-symbol.
versions valid in September 2016.
versions valides en Septembre 2016.
EN301489-1 V1.9.2 (2011)
EN301489-3 V1.6.1 (2013)
EN60065:2014
EN300220-1 V2.4.1 (2015)
EN300220-2 V2.4.1 (2015)
EN301489-1 V1.9.2 (2011)
EN301489-3 V1.6.1 (2013)
EN62479:2010
DECLARATION OF CONFORMITY
MrHandsfree iBell Set KB300
11-2016/V1
Page is loading ...
  • Page 1 1
  • Page 2 2

MRHANDSFREE iBell set KB300 User manual

Brand
MRHANDSFREE
Model
iBell set KB300
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Other documents