Craftex B2463 Owner's manual

Brand: Craftex

Model: B2463

Type: Owner's manual

FLOOR STAND FOR

MAGNIFYING LAMP

Assembly Instructions

2

ASSEMBLY

This lamp stand comes complete with all its

parts in a box; 2-piece Base, 1 Support Bar,

4 Swivel Casters, 2 Base Brackets, 4 Lock

Washers, a Knob, 2 Nuts, and a Wrench.

To assemble the stand, follow the

instructions below.

Place one lock washer on each caster and

thread the casters into the pre-drilled holes

on both ends of the two base pieces. Using

the wrench provided, tighten the nut and

attach the casters to the base pieces as

shown in figure-1.

Figure-1 Installing the casters

Cross the two base pieces with the cut-

outs, in the middle part of both pieces

matching as shown in figure-2.

Figure-2 Attaching the two base pieces

Place one of the two base brackets on the

base with the hole on the bracket aligned

with the one on the base. See figure-3.

Thread one of the two nuts provided onto

the threaded end of the support rod and

insert the support rod through the hole on

the bracket and the base. See figure-3.

Figure-3 Attaching the bracket, nut and

support rod

Turn the base upside down and place the

second base bracket and the knob with the

rod passing through the holes on both.

Thread the second nut onto the support rod

until the nut is into the knob and tighten the

nut properly using the knob. See figure-4.

Figure-4 Installing the bracket, knob & nut

1
2

Craftex B2463 Owner's manual

Brand: Craftex

Model: B2463

Type: Owner's manual

Other documents