5
SINGLE WAVELENGTH : Repeatedly press and release Button F until the
desired wavelength is selected (this single wavelength will be delivered for the entire
treatment duration) then go to step 7.
DUAL - WAVE : Repeatedly press and release Button E until the desired wavelength
combination is selected (these two wavelengths will be delivered together for the entire
treatment duration) then go to step 7.
TRI - WAVE : Repeat step 4 and step 5. The three wavelengths selected, will cycle in
sequence as single colours for 2 minutes (wavelength 1), 2 minutes (wavelength 2) then
one minute (Near Infrared - NIR), until the end of the programme.
Set the desired treatment duration. Button G will decrease treatment time (minimum
5 minutes) whilst Button H will increase it (maximum 60 minutes). The recommended
treatment duration is 20 - 30 minutes, and can be used daily if required.
Connect the appropriate end of the ‘electricity supply cable’ (see page 3) into power cable
Port C at the front of the control panel, and plug the opposite end into the electric wall socket
or adapter, Light B will illuminate, indicating that power is being supplied to the control panel.
Connect the appropriate end of the ‘mask to control panel cable’ (see page 3) into Port A at
the front of the control panel, and the opposite end into Power supply Port 4 found at the chin
of the Mask
Press and hold Button D for 2-3 seconds, and release when you hear a short melody.
The LCD screen on the top of the control panel will illuminate. The control panel is now ready
for programming.
DÉESSE PRO
INSTRUCTIONS FOR USE