
8 US-EN
Risk of electric shock
~This appliance has a polarized plug
(one blade is wider than the other).
To reduce the risk of electric shock,
this plug is intended to fit in a polar-
ized outlet only one way. If plug
does not fit fully in the outlet, re-
verse the plug. If it still does not fit,
contact a qualified electrician. Do
not attempt to defeat this safety fea-
ture.
~To reduce the risk of fire or electric
shock, DO NOT use this fan with
any solid-state speed control devic-
es.
~Never switch on the device if there
is visible damage to the device or
the power cable, or if the device
has been dropped before.
~
Only connect the mains plug to a
properly installed and easily accessi-
ble wall socket whose voltage corre-
sponds to the specifications on the
rating plate. The wall socket must
continue to be easily accessible after
the device is plugged in.
~Ensure that the power cable cannot
be damaged by sharp edges or hot
surfaces.
~Do not fold and crush the power ca-
ble.
~When using the device, ensure that
the power cable cannot be trapped
or crushed.
~The device is not fully disconnected
from the power supply, even after it
is switched off. In order to fully dis-
connect it, pull out the mains plug.
~When removing the mains plug
from the wall socket, always pull the
plug and never the cable.
~Disconnect the mains plug from the
wall socket...
…if there is a fault,
…when you are not using the de-
vice,
…before you clean the device and
…during thunderstorms.
~To avoid any risk, do not make
modifications to the product.
~Fully unwind the mains cable during
use to avoid overheating and
scorching.
~When using an extension cable,
this must correspond to the applica-
ble safety regulations.
Risk of material damage
~Never place the device on hot sur-
faces (e.g. hob plates) or near heat
sources or open fires.
~Only use the original accessories.
~Do not use any astringent or abra-
sive cleaning agents.
~Plastic parts should be cleaned with
mild soap and a damp cloth or
sponge. Thoroughly to remove soap
film with clean water.
__332413_1907_Tower Ventilator_B9.book Seite 8 Mittwoch, 6. November 2019 12:46 12