MyFridge MF5M Operation
11
7.1 Energy saving tips
• Choose a well ventilated location which is protected from direct sunlight.
• Allow warm food to cool down first before placing it in the cooling device to
keep cool.
• Do not open the cooling device more often than necessary.
• Do not leave the cooling device open for longer than necessary.
7.2 Using the cooling device
A
I
➤ Place the refrigerator on a firm base.
Ensure that the ventilation slots are at least 10 cm away from the wall so that the
heat that arises during operation can be drawn off.
I
➤ Insert the flat plug of the 230 V cable (fig. 1 2, page 3) into the socket
(fig. 2 1, page 3) on the appliance and insert the power plug into the 230 V
socket.
or
➤ Insert the flat plug of the 12 V cable (accessory) into the DC socket (fig. 2 2,
page 3) and connect it to the cigarette lighter socket or a 12 V socket in your car.
➤ Push the switch (fig. 3 3, page 4) on the control panel to “HOT” or “COLD” to
switch the device on.
NOTICE!
• When using the refrigerator as a milk cooler, also see the instructions
in the customer documentation of your coffee maker.
• Like every refrigerator, your cooler must be properly ventilated so
that any heat created can dissipate. Otherwise, it may not work
properly.
NOTE
Seal the opening on the side of the appliance with the plug if you have
not fed a tube inside (fig. 3 A, page 4).
NOTE
For use as a milk cooler for coffee makers only, the refrigerator has holes
in both sides, sealed with a black plug (fig. 3 A, page 4). Remove the
plug (fig. 3 B, page 4) and push the milk tube supplied into the
appliance. Now the coffee maker can draw up cold milk directly from
a suitable vessel inside the refrigerator.
MF5M-O-16s.book Seite 11 Mittwoch, 19. Juni 2019 8:48 20