Battery/Peripherals Enclosure PN 50295:B 07/24/2001
This cabinet consists of a backbox with an integral,
lockable door that is hinged on the bottom to swing
down for access.
It is designed to be mounted a minimum of 6 inches
(15.24 cm) below the fire alarm control panel
(FACP). When both cabinets are surface mounted,
the knockout in the bottom-right corner of the FACP
will line up directly above the knockout in the top-
right corner of this enclosure.
This enclosure should be mounted in a clean, dry,
vibration-free area, using the six holes provided.
Note: The enclosure has 0.875 in. (2.2225 cm)
knockouts which accept standard 0.75 in. (1.905 cm)
conduit.
FACP
Battery/Peripherals Enclosure
6 inch
minimum
(15.24 cm)
Conduit
7.730 in.
(196.342 mm)
2.66 in.
(67.564 mm )
2.80 in. (71.12 mm)
24.125 in. (612.775 mm)
23.750 in. (603.25 mm)
16.00 in. (406.4 mm)
15.00 in.
(381 mm)
14.75 in
(374.65 m
10.00 in.
(254 mm)
8.00 in.
(203.2 mm)
2.125 in.
(53.975 mm )
3.875 in.
(98.425 mm )
1.25 in
(31.75 mm)
7.730 in.
(196.342 mm)
4.00 in.
(101.6 mm)
7.250 in.
(184.15 mm)
2.00 in. (50.8 mm)
3.250 in. (82.55 mm)
14.06 in.
(357.124 mm)
Top
Front (without door)
DoorLeft Side
Battery/Peripherals Enclosure
Product Installation Document
PN 50295:B 07/24/2001 ECN 01-250