Hogtunes SGF GRILL-AA User manual

Start by removing the outer fairing. NOTE: A towel or something similar over your

front fender can help prevent dings or scratches in case something drops!

Remove the speaker/grill assembly from the bike. The factory grill cloth is glued to a

plastic mesh, and together, is two way taped to the main body of the grill assembly.

You can usually peel away the mesh from the body of the grill by hand. With the

factory grill cloth/mesh off, you should see the exposed two-way tape used to hold

the factory mesh on the main grill body. In most cases the factory two-way tape will

hold the new mesh in place, but new two-way tape is supplied in the box if you need

it*. Take a moment and make sure the new mesh is oriented so everything lines up

properly. Re-install the speaker/grill assembly into the fairing.

*Please note that most adhesives work best at room temperature or higher!

For custom applications, the metal mesh is thick enough so it shouldn't warp during

such processes as powder coating, polishing, painting, chroming etc.

Harley-Davidson, Electra Glide, Street Glide, and Ultra Classic, are Trademarks, and/or

Registered Trademarks of Harley-Davidson, Inc., Milwaukee, Wisconsin, USA, and if

Used or Implied are for Reference Only. There is No Aliaon Between

Harley-Davidson, Inc., and Hogtunes Inc.

Hogtunes Inc. Unit#14-70 Ellis Drive, Barrie, Ontario, Canada, L4N-8Z3

Tel: (705)-719-6361 Email: [email protected]

The Mesh Parts In This Kit Are Designed To

Replace The Front Speaker Grill Cloth On

1996-2013 HD Street Glides, Ultras,

Classics, and Standards

SGF Grill-AA Manual