Hogtunes 57Mesh Installation guide

Hogtunes Inc., Unit 14 - 70 Ellis Drive, Barrie, Ontario, Canada, L4N-8Z3

Tel: (705) - 719-6361 Email: [email protected]

www.hogtunes.com

57 Mesh Instructions

This Kit is Sold As Replacement Grills Only

DO NOT USE THIS KIT TO ADAPT ANOTHER

BRAND OF 5x7” SPEAKERS TO YOUR BIKE!

Damage To Inner Fairing WILL Occur If Factory (OE) Screws Are

Used To Attach The Plastic Grill Rings To Your Fairing!

Hogtunes Assumes ZERO Responsibility For This!

Please choose the install option below for

the speakers currently in your bike

With the outer fairing removed, you will remove the speakers from

the grills and put aside. The grills can now be removed from the bike.

Put the new grills in place and attach to the fairing using the screws

and “speed nut” just removed. The speakers will now bolt back into

your new grills. NOTE: The screws that came with your Hogtunes

5x7’s are correct for these grills and will not damage inner fairing.

Hogtunes 57 Mesh grills are made up of a plastic “ring” and stamped

metal mesh. The mesh is secured to the plastic ring with double sid-

ed adhesive. Carefully separate the metal mesh from the plastic

ring. With the current speakers and grills in your bike removed, you

will have separate the grill from the ring currently in your bike. The

57 Mesh grill will have enough “tack” from the double sided

adhesive to stick to the grill frame you currently have. Re-install the

grill frames with the mesh attached, and re-install your speakers.

Option 1: If you already have Hogtunes 5x7” speakers in your bike

Option 2: If you DO NOT have Hogtunes 5x7” speakers in your bike