Bully CR-605L User guide

Type
User guide

Bully CR-605L is a hitch step that can be installed on a vehicle's hitch receiver to provide a step up for easier access to the truck bed or trailer. It is designed to fit both 2-inch and 1 1/4-inch hitch receivers and comes with an anti-rattle hitch stabilizer to prevent noise and movement. The hitch step also includes a 4-way flat connector for wiring, making it easy to connect to the vehicle's lighting system. Additionally, the hitch step has a weight capacity of 300 pounds, making it suitable for a variety of tasks.

Bully CR-605L is a hitch step that can be installed on a vehicle's hitch receiver to provide a step up for easier access to the truck bed or trailer. It is designed to fit both 2-inch and 1 1/4-inch hitch receivers and comes with an anti-rattle hitch stabilizer to prevent noise and movement. The hitch step also includes a 4-way flat connector for wiring, making it easy to connect to the vehicle's lighting system. Additionally, the hitch step has a weight capacity of 300 pounds, making it suitable for a variety of tasks.

ENGLISHENGLISH
2 3
1. Identify the correct mounting shaft size needed for you application.
Note: If your hitch did not come with a sleeve skip this step.
(2” Receiver) Make sure large sleeve is installed on mounting shaft.
(1 ¼” Receiver) Remove large sleeve from mounting shaft.
2. Install the anti-rattle hitch stabilizer.
Note: If your hitch did not come with a stabilizer skip this step.
A. Insert the hitch step and place your hitch pin in position. Push the anti-
rattlehitchstabilizerintothehitchreceivertightlytollupthegapon
the top of the bar. Mark the exact position.
B. Remove the hitch step from your receiver. Remove the tape backing on
the anti-rattle hitch stabilizer and reposition the stabilizer 1/16” in front of
yourmarkedposition.Pressdownontheshimrmlytoensurea
secure mount.
3. Identify and align the correct mounting hole on hitch step with the factory hitch,
Apply the appropriate size hitch pin (not supplied).
Note: It is recommended that a locking hitch pin be used to prevent theft.
4. Forwiringinstallation,ndyourvehicle’s4-wayatconnector
Note: Some vehicles may require an adaptor or extension cable.
5. Once installation is complete, make sure lighting functions are
working properly.
Note: Some vehicles may require a load resistor to get the lighting function to
work properly.
Pilot, Inc.
13000 Temple Ave. Industry, CA 91746
(800) 237-7560
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Bully CR-605L User guide

Type
User guide

Bully CR-605L is a hitch step that can be installed on a vehicle's hitch receiver to provide a step up for easier access to the truck bed or trailer. It is designed to fit both 2-inch and 1 1/4-inch hitch receivers and comes with an anti-rattle hitch stabilizer to prevent noise and movement. The hitch step also includes a 4-way flat connector for wiring, making it easy to connect to the vehicle's lighting system. Additionally, the hitch step has a weight capacity of 300 pounds, making it suitable for a variety of tasks.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages