Bully CR-605L User guide

Hello! I am an AI chatbot trained to assist you with the Bully CR-605L User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

ENGLISHENGLISH

2 3

1. Identify the correct mounting shaft size needed for you application.

Note: If your hitch did not come with a sleeve skip this step.

(2” Receiver) Make sure large sleeve is installed on mounting shaft.

(1 ¼” Receiver) Remove large sleeve from mounting shaft.

2. Install the anti-rattle hitch stabilizer.

Note: If your hitch did not come with a stabilizer skip this step.

A. Insert the hitch step and place your hitch pin in position. Push the anti-

  rattlehitchstabilizerintothehitchreceivertightlytollupthegapon

the top of the bar. Mark the exact position.

B. Remove the hitch step from your receiver. Remove the tape backing on

the anti-rattle hitch stabilizer and reposition the stabilizer 1/16” in front of

  yourmarkedposition.Pressdownontheshimrmlytoensurea

secure mount.

3. Identify and align the correct mounting hole on hitch step with the factory hitch,

Apply the appropriate size hitch pin (not supplied).

Note: It is recommended that a locking hitch pin be used to prevent theft.

4. Forwiringinstallation,ndyourvehicle’s4-wayatconnector

Note: Some vehicles may require an adaptor or extension cable.

5. Once installation is complete, make sure lighting functions are

working properly.

Note: Some vehicles may require a load resistor to get the lighting function to

work properly.

Pilot, Inc.

13000 Temple Ave. Industry, CA 91746

(800) 237-7560

[email protected]

/

Other documents