2. Legrand
  3. V2410D

Legrand V2410D, 2400 Series Small Raceway Divided Entrance End Fitting - 2410D, 2410D-FW Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Legrand V2410D Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
2410D
Divided Entrance End Fitting
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 007 122 – October 2007
Wiremold/Legrand electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Wiremold/Legrand electrical
products may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
1. Slide the tab on the divider into the slot on the
Entrance End Fitting base.
2. Slide the tongue on the Entrance End Fitting
base into the 2400D Raceway Base.
3. Attach Entrance End Fitting to the wall using #8 (5/16"
[7.9mm] head size) flat head fasteners or equivalent.
4. Slide the Raceway Cover into the slot on the Divider
and snap the Cover onto the Raceway Base.
Wiremold / Legrand
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
570 Applewood Crescent • Vaughan, Ontario L4K 4B4
1-800-723-5175 • FAX 905-738-9721
1 007 122 1007
© Copyright 2007 Wiremold / Legrand All Rights Reserved
5. Place the Cover on the Entrance End Fitting and
tighten the screws.
/