A
B
Choose the bolt that
is just a bit longer than
your spindle width.
Too long
Too short
Installation instructions
2. Insert sleeve nut into rail B
3. Spin correct sized bolt into sleeve nut, just a couple turns to
stay on the sleeve nut.
4. Slide wide bolt end into rail A
5. Insert plastic plug into road keyhole of rail A (this will help that
rail B doesn’t slide off during install)
1. Determine bolt length by holding
a bolt up to your spindles, a bolt
that is about the same length or
slightly longer than your spindle
depth is the right one.
6. Attach mounting rail according to graphic.
7. Tighten slightly with Allen wrench on
each side.
8. Level mounting rail and tighten snugly.
Check for tight t monthly.
Please read instructions before installing for best results.
WARNING: YOU, THE PURCHASER, ASSUME THE RISK OF PROPERLY USING AND MOUNTING THE HOLD IT MATE SYSTEM, INCLUDING ANY ADDITIONAL AC-
CESSORIES (TOGETHER, THE “PRODUCT”), TO APPROPRIATE STRUCTURES AND LOCATIONS. THE PRODUCT MUST NOT BE MOUNTED TO ANY STRUCTURE
NOT RATED TO HOLD PRODUCT’S WEIGHT. is Product is sold “AS-IS” without a warranty of any kind, expressed or implied, including any warranties or conditions of mer-
chantability and tness for a particular purpose. In no event shall there be any liability for any direct, indirect, punitive, incidental, special, consequential or other damages arising out
of or related to the use or misuse of this Product. e purchase and use of any additional accessories shall be limited to their specied use, and such use shall be subject to the warning
set forth herein. If you do not accept the terms provided herein, please contact customer service at support@holditmate.com to receive a refund of the purchase price within thirty
(30) days from purchase.
2
6
87
1
3
4
5
Visit holditmate.com/install for a video tutorial.
/
