Fire Sense 61709 User guide

OPTIONAL TABLE ASSEMBLY INSTRUCTIONS

This patio heater comes with an optional table assembly that may be installed on the heater. If you wish

to install this feature, please follow the instructions below (no tools required for assembly):

FIG 1: Slide 1 piece part B over part A and up to

the top of part A.

FIG 2: Insert part A through hole in part C.

FIG 3: Slide 1 piece part B over part A until it is

flush against the underside of part C.

FIG 4: Screw part D onto end of part A and up until

it is flush with the underside of part C.

FIG 5: Slide part E down over pole, then slide table

assembly over pole and stop at desired height.

FIG 6: Screw part E over part A to secure table in

position. Once table is at desired height, tighten

part E.

FIG 1

FIG 2

FIG 3

FIG 4

FIG 5

FIG 6