Fellowes Helios 60 Owner's manual

Performance Thermal Binder

Helios 60

TM

Please read these instructions before use.

Lire ces instructions avant utilisation.

Lea estas instrucciones antes del usarlo.

Diese Anleitungen vor Gebrauch genau durchlesen.

Primo dell’uso, si raccomanda di leggere questo

manuale di istruzioni.

Dese instructies voor gebruik lezen.

Läs dessa anvisningar innan du använder apparaten.

Læs venligst denne vejledning før anvendelse.

Lue nämä ohjeet ennen käyttöä.

Vennligst les nøye igjennom denne bruksanvisningen før bruk.

Przed użyciem proszę zapoznać się z tą instrukcją.

Перед эксплуатацией устройства ознакомьтесь

с содержанием данной инструкции.

Διαβάστε τις παρακάτω οδηγίες πριν από τη χρήση.

Kullanmadan önce lutfen bu talimatlari okuyen.

Pred poużitím si pročtěte tyto pokyny.

Pred poużitím si prečítajte tieto pokyny.

Kérjük, hogy használat elött olvassa el az

utasításokat.

Leia estas instruções antes da utilização.

F

GB

D

I

E

NL

S

DK

FIN

N

PL

RU

GR

TR

CZ

SK

H

P

Cycle No. 12345678910

Max thickness (mm) 6 12 18 24 30 36 42 48 54 60

Binding period (secs) 60 70 80 100 120 130 140 150 160 180

HELIOS 60 / AUTO-SENSE BINDING CYCLE MATRIX

BINDING MACHINE CONTROLS / QUICK START GUIDE 3

ENGLISH 4-7

FRANCAIS 8-11

ESPAÑOL 12-15

DEUTSCH 16-19

ITALIANO 20-23

NEDERLANDS 24-27

SVENSKA 28-31

DANSK 32-35

SUOMI 36-39

NORSK 40-43

POLSKI 44-47

РУССКИЙ 48-51

EΛΛΗΝΙΚΑ 52-55

TÜRKÇE 56-59

ČESKY 60-63

SLOVENSKY 64-67

MAGYAR 68-71

PORTUGUÊS 72-75

INDEX

B DE F

BINDING MACHINE CONTROLS

QUICK START GUIDE

M

H / K

I

1

3

A

O

J

N

L

C

G

2

3

4

5

6

7

8

9

10

11

12

CAPABILITIES

When binding;

- plug the machine into an easily accessible socket.

- to prevent electrical shock - do not use the appliance close to water, do not spill water on to the appliance, power cord or wall

socket.

Performance

Entry width 310mm

Binding capacity (max) 60mm / 600 sheets (80gsm)

Estimated heat-up time 4 minutes

Cool down time 30-60 minutes

Binding cycles 1-10 cycles / 1-3 minutes

Ready indication Light & beeps

LED interface Yes

Auto-Sense Yes

Heat-Shield Yes

Power Save / Auto shut-off Yes (30 mins)

Multiple Document Binding Yes

Voltage / Frequency /

Current(Amps) 220-240V AC, 50/60Hz, 2.7A

Wattage 600 Watts

Dimensions (HxWxD) 530 x 230 x 100mm

Net weight 2.6 kg

Binding capacity

The maximum sheet capacity can be a single (up to 500

sheet max) or multiple documents up to approximately 600

sheets max.

Eg: 1 x 500 sheets = 500 max

3 x180 sheets = 540 max

6 x 60 sheets = 360 max

8 x 30 sheets = 240 max

2 x 300 sheets = 600 max

DO ensure the machine is on a stable surface.

DO test scrap sheets and set the machine before use.

DO remove staples and other metal articles prior to binding.

DO keep the machine away from heat and water sources.

DO turn off the machine after each use.

DO unplug the machine when not in use for an extended

period.

DO use binding covers designed for use at the appropriate

settings.

DO keep away from pets, while in use.

DO NOT leave the power cord in contact with hot surfaces.

DO NOT leave power cord hanging from cupboards or shelves.

DO NOT use appliance if the power cord is damaged.

DO NOT attempt to open or otherwise repair the machine.

DO NOT exceed the machines quoted performance.

DO NOT allow children to use this machine without adult

supervision.

DO NOT bind sharp or metal objects (eg: staples, paper clips).

DO NOT bind heat-sensitive documents (eg: tickets, ultra-

sounds etc).

DO NOT touch the heating plate while binding - it is very hot.

IMPORTANT SAFETY INSTRUCTIONS

4

ENGLISH

Please read before use and keep for future reference.

CAUTION:

Unplug the machine at the wall. Allow the machine to cool.

The outside of the machine can be cleaned with a damp cloth. Do not use solvents or flammable materials to polish the machine.

STORAGE & CLEANING

‘System-Check’ function

When switched on, the machine performs a

‘System-Check’ function. The control panel

illuminates LED neons in sequence to check their

operation.

‘Thermo Sense’ function

When opening the document clamp and loading

documents for binding, the machine calculates the

optimum binding cycle period. There is no need to

manually input the cycle period.

‘Heat-Shield’ function

The document clamp operates as a ‘Heat Shield’ to

prevent operators from accidentally touching the

heating plate.

‘Auto-Off’ function

If the machine is not active for 30 minutes, the

‘Auto-Off’ function will place the machine into

standby mode. The ’Power-On’ LED will flash

red and green. To operate the machine, press the

‘Power-On’ button.

• Always put the document into the appropriate sized

binding cover.

• For better results, consider including blank sheets

to fill the thermal cover to capacity.

• Always test bind with a similar size and thickness of

thermal covers before final process.

• Helios has an angled heater mechanism to ensure

correct document alignment with the document

support during the binding process.

• For best results, use Fellowes® brand supplies.

• Thermal binding covers work best with thin and

uncoated types of paper. Care should be taken

with thick and coated papers to ensure satisfactory

results.

• If the sheets have not been glued completely to the

cover, the document can be re-processed to improve

the result.

• Ensure the sheets are well aligned and touching

the glued spine of the thermal cover by tapping the

collated document in the cover onto a flat surface.

This can be done before and after the binding

process.

A On/off switch (rear side) I Lid lock (2)

B Power On button & LED J Binding channel

C Binding thickness guide K Document support

D Timer selection (increase) L Illuminated user interface

E Timer selection (decrease) M Cooling vents

F Select / OK button N Document clamp (binding)

G Thickness setting / timer selection O Cooling rack

H Lid

BINDING MACHINE CONTROLS

FEATURES & TIPS

5

Switch the power on (located at the rear side).

The ‘Power-On’ button will be red. To activate the ma-

chine, press the ‘Power-On’ button on the control panel.

The machine will warm-up, the red LED will flash. The

machine will ‘beep’ (3x) and the LED turns green when

the machine is ready to bind.

Prepare the documents by loading the sheets into the

thermal covers. For best results, do not to place too

many or too few sheets into the cover. Use the binding

thickness scale as a guide. The guide is calibrated in

6mm widths. Helios 60 will accept single or multiple

documents up to a combined total thickness of 60mm

(approximately 600 sheets / 80gsm).

The ‘Auto-Sense’ function calculates the optimum bind-

ing cycle based upon the total binding thickness.

Pull open the document clamp (Heat-Shield feature),

insert the documents into the binding channel. Ensure

the binding covers spine touches the heating element.

The selected binding cycle is shown with blue LED. Use

the timer selection buttons to navigate up or down the

scale, if required. The scale has 10 settings. Eg: 6mm

document thickness = setting 1 (up to 60 sheets),

30mm document = setting 5 (up to 300 sheets).

Start the binding cycle by pressing the ‘Select / OK’ but-

ton. The blue LED will start flashing and counting down,

in sequence. When the cycle is complete, the machine

will beep (3x). The blue LED will switch off.

The machine has an integral cooling tray. It can be

extended from the back of the machine and can also be

pulled upwards to accept larger documents.

When the binding cycle is complete, immediately

remove the documents and place in the cooling tray

or on a flat surface to allow the document to cool. The

document can be removed from the machine mid-cycle

if required, take care – the glue may be hot and

melted.

5.

6.

7.

8.

9.

10.

11.

12.

HOW TO BIND

6

Let our experts help you with a solution.

Customer Service...

www.fellowes.com

Always call Fellowes before contacting your place of purchase,

see the rear cover for contact details.

NEED HELP?

Ensure the machine is on a stable surface. Check there

is enough clear space around the machine to operate

safely.

Select the correct power lead for the appropriate power

supply. Insert the power lead into the power socket

(located at the rear of the machine).

Plug the machine into an easily accessible mains socket.

Switch the mains supply on.

Open and lift the lid by releasing the safety catches on

the front of the lid.

1.

2.

3.

4.

BEFORE BINDING

Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of purchase

by the original consumer. If any part is found to be defective during warranty period, your sole and exclusive remedy will be repair

or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling

or unauthorised repair. Any implied warranty, including that of merchantability or fitness for particular purpose, is hereby limited

in duration to the appropriate warranty period set forth above. In no event shall Fellowes be liable for any consequential damages

attributable to this product. This warranty gives you specific legal rights. You may have other legal rights that vary from this warranty.

The duration, terms and conditions of this warranty are valid worldwide, except where different limitations, restrictions or conditions

may be required by local law. For more details or to obtain services under this warranty, please contact Fellowes or your dealer.

WORLDWIDE WARRANTY

Thank you for purchasing a Fellowes product. Please visit www.fellowes.com/register to register your product and benefit from product

news, feedback and offers. Product details can be found listed on the rating plate positioned on the rear side or underside of the

machine.

PRODUCT REGISTRATION

Problem Possible cause Solution

No ‘red’ power on LED Machine is not switched on

Switch on machine at rear next to plug

inlet and at the wall socket

No ‘green’ ready light after a long period Machine is in a hot or humid area

Move the machine to a cooler and

dry area

Loose and unglued sheets

Binding cover may be too thick to bind

Process the documents again, ensure

sheets are in contact with the glued

spine by tapping gently on a flat

surface

Timer setting may be incorrect

Check timer setting is correct and

process the document again

Loose and glued sheets

The cover size is too small for the number

of sheets

Check the number of sheets is ap-

propriate for the cover width. Select

larger spine width if necessary

Extended heating cycle

Check timer setting is correct. Ensure

prompt document removal

Timer setting may be incorrect

Documents left on the heater plate after the

cycle is complete

TROUBLESHOOTING

W.E.E.E.

This product is classified as Electrical and Electronic Equipment. Should the time come for you to dispose of

this product please ensure that you do so in accordance with the European Waste of Electrical and Electronic

Equipment (WEEE) Directive and in compliance with local laws relating to this directive.

For more information on the WEEE Directive please visit www.fellowesinternational.com/WEEE

7

Page is loading ...

1789 Norwood Avenue, Itasca, Illinois 60143-1095 • USA • 630-893-1600

Australia

Benelux

United Kingdom

United States

Canada

China

Deutschland

España

France

Italia

Japan

Korea

Polska

Singapore

fellowes.com

2008 Fellowes, Inc. Part No. 403836

Declaration of Conformity

Fellowes Manufacturing Company

Yorkshire Way, West Moor Park, Doncaster, South Yorkshire, DN3 3FB, England declares that the model Helios 60 conforms with

the requirements of (RoHS) the Restriction of Hazardous Substances Directive 2002/95/EEC. The Low Voltage Directive 72/73/

EEC as amended by directive 92/68/EEC. The Electromagnetic Compatability Directive 89/336/EEC as amended by directive

92/31/EEC & 96/68/EEC and the following Harmonised European Normes EN standards and IEC standards.

Information Technology Product: EN-60950-1 2001 / IEC-60950-1 2001

EMC: EN-55014-1 / A2 : 2002 EN-55014-2 / A1 : 2001 EN-61000-3-2 : 2000 EN-61000-3-3 / A1 : 2001

Itasca, Illinois, USA

March 2009 James Fellowes

Help Line

Europe 00-800-1810-1810

Fellowes

Australia +61-3-8336-9700

Benelux +31-(0)-76-523-2090

Canada +1-905-475-6320

Deutschland +49-(0)-5131-49770

España / Portugal + 34 902 33 55 69

France +33-(0)-1-30-06-86-80

Italia +39-71-730041

Japan +81-(0)-3-5496-2401

Korea +82-(0)-2-3462-2844

Malaysia +60-(0)-35122-1231

Polska +48-(22)-771-47-40

Russia +7-(495)-228-14-03

Singapore +65-6221-3811

United Kingdom +44-(0)-1302-836836

United States +1-630-893-1600

Fellowes Helios 60 Owner's manual

Related papers

Other documents