HOW_INSTRUC_DOOR_09.2018_V1
A
B
Page 1 of 2
21
3 4
HOW TO FIT
SLIDING DOORS
TOOLS REQUIRED:
Assembly Instructions
V1
1- Screw top track to ceiling, using equal spacing.
2- Position bottom track on the floor. (Do not fix yet).
1- Measure the width at the top and bottom of your opening.
2- Mark this on your top and bottom track sets minus 2mm
(taking off 2mm allows for an easier fit). Cut the tracks.
Position door on both sides of the track and level up. (Do this by
moving the bottom track). Mark the floor once in position.
Insert door into back channel of top and bottom tracks.
Please check your opening for any
hidden electrical wires and water
pipes before / screwing.
Screws not supplied. Use suitable
screws and plugs.
All doors are made to suit an opening
height of 2277mm.
A higher ceiling needs to be reduced
ensuring the opening is level and
squared up.
Not suitable for bathrooms.
Install flat side of
track to the door.
Cut the tracks using a
fine tooth hacksaw.
Width of base
opening.
Top track
Floor track
Width of top opening.
HOW_INSTRUC_DOOR_09.2018_V1
7
6
8 9
Page 2 of 2
For all track types, measure in 100mm from wall and then space
out evenly across the length of the track (approx 500mm).
After marking where the drill holes will be, drill through the track into the
floor. Fix by screwing into the floor using suitable fixings.
(You can use ‘double sided foam tape’ to secure bottom track if preferred).
Re-insert door. Make sure to fit the back doors first.
Adjust the bottom wheels using a screwdriver, altering the height
and angle of each door to suit your space. Turn the screw
clockwise to raise the door and anti-clockwise to lower the door.
1 - Rotate the flag
out and push down
into the track.
2 - Rotate back into
original position.
Repeat steps 7 & 8 on all doors to complete the wardrobe.
BACK OF WARDROBE
100mm
Approx
500mm
1
2
Remove the door.
5
ENSURE YOUR FLOOR IS LEVEL. IF IT ISN’T, YOU MAY
REQUIRE ADDITIONAL MATERIAL UNDER & ALONG THE
ENTIRE LENGTH OF THE FLOOR TRACK TO LEVEL IT UP.
/
