Hoopo Protector Mounting User guide

Protector Mounting Guidelines

1. Place & attach the label on the installation surface at the selected position.

2. Drill guiding holes 1&2 with 4.8 mm ( 3/16") bit.

3. Place the hooposense unit inside the protector in one of two optional positions;

A - Suitable for vertical installation surface (gps antenna points to the sky).

B - Suitable for horizontal installation surface (gps antenna points to the sky).

5. Use 2 hexagon head drilling screws and washers.

Screws DIN 7504K-Z.P 6.3X50 (#14x2"); Washers DIN 125A Part1 - Z.P. 8mm (5/16)

Note: Please do not over-tight the screws.

Protector Installation Label:

Protector Mounting Guidelines

Position A - Suitable for vertical installation surface (gps antenna points to the sky)

Protector Mounting Guidelines

Position B - Suitable for horizontal installation surface (gps antenna points to the sky)