INSTRUCTION MANUAL
Baby Unit
Pairing with SOS
Microphone Loudspeaker
USB port
Room Temperature sensor
:
Gather rm temperature infrmn
Pairing with camera
Start to use monitor
Status bar
Menu operation
Signal strength reference
Camera number
System
Baby rm temperature
Bery level
Talk funvated
Zm in is vated
Mitmuted
Temperature alert is avated
Scan view is vated
ADD: Add aal camera
Step 1: Mve the parent unit tthe same area as the camera. Bth parent and
baby unit are .
Step 2: Select camera number in Add camera Menu. Press “tegin pairing.
Step 3: Within 50 secress “Pairinge camer, the
Delete camera: Delete paired camera frm the added camera list.
Step 4: Once successfully paired, the camera light will stg and videwill
appearthe mtcreen within 50 sec.
SCAN: Display paired camerae bye.
Off:.
Quiet: Baby cry a lle bit tvate the Parent Unit.
Medium: Baby cry merate tvate the Parent Unit.
Loud: Baby cryr tvate the Parent Unit.High/Low: Beep Alarm is issued when rm temperature is
highe than this sng.
C: Display temperature in Celsius scale.
F: Display temperature in Fahrenheit scale.
Time seng:.
Off In, 1.5X In, 2X
Zoom
Explanaon On/Off:menu.
JouSecu’s baby monitor warranty policy
JouSecu will repair (at our option) your unit free of charge for 12 months from the date of purchase if the
unit is defective in workmanship or materials. To claim your repair/replacement, the product must be
returned to JouSecu together with a copy of the purchase receipt. In the absence of the purchase receipt,
the warranty will be 12 months from the date of manufacture. This warranty does not apply to normal wear or
damage from misuse, abuse, improper and handling, installation, accident, unauthorized repair or alteration.
IC Radire Statement:
This equipment cmplies with IC RSS-102 radiere limit set frth fr an uncntrlled envirment. This equipmentd
be installed arated with minimum distance 20cm between the radiatr and ydy.
Cet équipement est cnfrme aux CNR-102 d'Industrie Canada. Cet équipement it êtreinstallé et lisé avec une distance minimale
de 20 cmètres entre le radiateur et vtrecrps. Cet émeur ne it pas être ccalisées rant en cnn avec
autreantenne émeur. es antennes lisées ur cet émeur vent être installés urnir une distance de sépar'au
m20 cemètre de tte pere etit pas être ctuée ni feavec une au
This device complies with Part 15 of the FCC Rules. Operon is subject to the following two c:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operon.
FCC Can
To assure conued compliance, any changes or modicons not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. (Example -use only shielded interface cables when
connng to computer or peripheral devices).
FCC Radire Statement
This equipment compliew with FCC RF radion exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of emeters between the radiator and your
body.
This transmr must not be co-located or operng in conjunon with any other antenna or transmr.
The antennas used for this transm must be installed to provide a separon distance of at leas from all persons
and must not be co-located or operng in conjunon with any other antenna or transmr.
Industry Canada Statement
This device cmplies with Industry Canada licence-exempt RSS standard.
Oper is ct t the flwing tw c: (1) this device may t cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
erthe device.
résent appareil est cnfrme aux CNR d'Industrie Canada applicables aux appareils radiexempts
de licence'explitst autrisée aux deux cvantes :
(1) l'appareil ne it pas prre de brllage, et (2) l'lisateur de l'appareil t accepter tut
bruillage radlectrique subi, même si le bruillage est susceble d'en cmprmre le
fment.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communicaotions. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Ast Parent Unit CD Brightness lighterr darker.
Adjust camera volume.
OFF: Devate .
On: Avate . When the feeding
Turn off screen and leave audio on:
ECO ECO mode:
T
OFF: .
Repeat: Repeat all lullabies
Kick Stand
Flit the kick stand
and place the Parent
Unita stable level
surface.
Antenna
ntenna taveer receivide
Reset
parant unit, and restart.
Loudspeaker
Base Braket USB port
Battery Location
en the rear
panel tchange
bery.
.
4
Pairing with camera
Pairing with SOS
SOS button
Calibraon:.
Off/On: .
On/Off:
Split screen
B255
Power saving mode:
Tvate Parent unit frm Pwer saving me
Reset:
Language: