B152/B152-2T
WARNING
STRANGULATION HAZARD
Children have STRANGLED in cords.
Keep this cord out of reach of children (more than 3 feet/1 meter away
from the crib). Never use extension cords with AC adapters. Only use the
AC Adapters provided.
WARNING
Adult assembly required. Keep small parts
away from children when assembling.
Warning Information
Keep this instrmanual fr
future reference.
Fr adult usey.
WARNING
When an AC Adapter is plugged intan electricaltlett the eed end.
Test baby mtr befrrst use, percally, and when changing lcthe baby unit(Camera).
t use mtr near water (Such as bathtub, Sink, etc)
Keep parent unit away frm heatrces (Such as stves, radiatrs, etc)
Make sure there is prr velaraby unit and parent unit.
This prctt a tyt allw children tay with it.
The mains plug r an appliance cr is used as the discect device, the discct device shall
remain readilyerable.
The baby mtr t be cred as a medical device. While using the baby mtr, it is
strgly recmmended t have an adult directly checking yr baby. Premature babies r children
cred at risk must be supervised by yr pediatriciarther medical sta.
THIS PRODUCT CANNOT REPLACE
RESPONSIBLE ADULT SUPERVISION
Usey theriginal rechargeable bery prvided.
tt-circuit supply terminals.
Remve bery when prct is stred frg permr when b ery is exhausted.
eexhausted bery prerly.
Keep all beries away frm children.
The apparatus shall t be eed t dripping r splashing and that ects ed with liquids, such
as vases, shall be placthe apparatus.
Dangeeery is incrrectly replaced. Replacey with the samr equivalent type.
Beries (bery pack r beries installed) shall t be eed t excessive heat such as sunshine, re
r the like.
Bery Warning
Precns
t verad wall tlets, exte crds, integral cnvenience
receptacles as this can result in a riskrer electricck.
The baby mt wrks ber in temperature ranging between 0
and 40 (32 and 104 )
t dismantle the appliance. It t cntain any parts that may
be used independently.
Never e the baby mtr f g peri t sun’s direct rays and
never place it next tarcat, in a damvery dusty rm.
Never push ects any kind int this prct thrgh ings as
they may tch danger vtage nts r rtt parts that c
result in a re electric ck. Never spill liquid any kind the
prct.
t empt t service this prct yrself as g
remving cvers may ee y t danger vtage r ther hazards.
Refer all servicing tarvice per
The prct ld be mnted t a wall r ceiling inly as
recmmended by the manufacturer.
FederammunicmmissiInterference
Statement
This equipment has been tested and f t cmply with the
limits f a Class B digital device, pursuant t Part 15 the FCC
Rules. These limits are designed t prvide reaable prten
against harmful interference in a resideal install.
This equipment generates, uses and can radiate radi frequency
energy and, if t installed and used in accrdance with the
instru may cause harmful interference t ra cmmunica-
Hwever, there is guarantee that interference will t
ccur in a pular install If this equipment cause
harmful interference t radi r televisi rece which can be
determined by turning the equipment and the user is
encraged t try t crrect the interference by the
flwing measures:
. Rrientrecate the receiving antenna.
. Increase the separetween the equipment and receiver.
. ct the equipment int an tlet a circuit dierent frm
that twhich the receiver is cected.
t the dealeran experienced raditechnician fr help.
This device cmplies with Part 15 the FCC Rules. Oper is ct t the fwing
twc:
(1) This device may t cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesirr.
FCC Can
T assure cnued cmpliance, any changes r mic t expressly apprved by the party
rle fr cmpliance cld v the user's autrity t rate this equipment. (Example -
ly shielded interface cables when cng tcmputerr peripheral devices).
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can
be used in portable exposure condition without restriction.
’s babynitr warranty licy
will repair r replace (at r yur unit free charge
fr 12 mnths frm the date purchase if the unit is defve in
wrkmanship r materials. T claim yur rereplacement, the
prct must be returned t tgether with a cpy the
purchase receipt. In the absence the purchase receipt, the warranty
will be 12 mnths frm the date manufacture. This warranty es t
apply t rmal wear r damage frm misuse, abuse, imprer strage
and handling, install, accident, unautrized repair r alter
Please cntact r Custmer service by Facek via
email fr details.
Industry Canada Statement
– This radio is designed for and classified as “General population/uncontrolled Use”, the guidelines are based on standards that were developed by independent scientific
organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons
regardless of age or health.The exposure standard for wireless radio employs a unit of measurement known as the Specific Absorption Rate, or SAR, the SAR limit set 1.6W/kg.
– Body-worn operation; this device was tested for typical body-worn operations with the back of the Monitor kept 0mm for body worn. To maintain compliance with RF
exposure requirements, use accessories that maintain a 0mm for body worn. The use of belt clips, holsters and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure requirements, and should be avoided.
– The highest reported SAR value for use at the ear is 0.546W/kg.
1 meter
Never place the baby unit crd
within 1 met
ect the small plugthe pwer adapter tthe Baby Unit and tther end ta
suitable electricatlet. Only use the encled adapter (51000mA).
1
2
Setup and use your digital video baby monitor
B.
C.
charged.
Notice:
If you use the parent unit for the first time, when you turn on the parent unit,
some boot menus will pop-up on the screen, we try to explation status and
function on these menus, please according to the tips to switch to the monitor
system interface. When you are fimaliar with this monitor, you could switch
off these on screen tips in menu.
Precaution: use of battery for Parent Unit
Only charge the battery when the battery life indicator is low. Constant
recharging of your battery before the low battery indicator light comes on will
decrease the life of your batteries.
A. Place Baby Unitat surface, such as a desk.
Function of keys and LED indicators
Parent Unit
Baby Unit
P
INSTRUCTION MANUAL
cg the pwer supply fthe Parent Unit.
ct the small plugthe pwer adapter tthe parent
unit and tther end ta electricatlet. Only use the enc
adapter(52000mA).
Recmmend chargingmat least 3rs befrerst use.
Antenna
:Camera Antenna
Microphone Loudspeaker
USB port
Pairing button
Power LED
Room Temperature sensor:
Gather rm temperature
infrmn.
OK
VIEW
OK
VIEW
Volume up:
Volume down:
PAIR
Kick Stand
Flit the kick stand and place
the Parent Unita stable level
surface.
Battery Location
en the rear panel tchange
bery.
Antenna
ntenna taveer receivide
Reset
restart.
USB port
USB port
Base Bracket
Press tep
Loudspeaker
MENU:
Press tswitc Pwer Saving (vce vme).
ress tst menu se
ress tst menu se
Prttalk tby unit.
Volume down/up
Talk
Up/Down
Camera Up/Down
Left/Right
Camera Left/Right
Select
Power Saving-on/off
VOL- VOL+
OK
VIEW
VOX
4Start to use monitor
Status bar
Menu operation
Signal strength reference
Camera number
Talk funvated
Zm in is vated
Lullaby is vated
Mitmuted
Temperature alert is avated
Ast Parent Unit LCD
Brightness lighterr darker.
.
ADD: Add aal camera
: .
Delete: Delete paired camera frm the list.
Repeat: Repeat all lullabies
Quiet : Baby cry a lle bit tvate the Parent Unit.
Acvaon sound level selecon and leave audio off in power saving mode.
Medium: Baby cry merate tvate the Parent Unit.
Loud
Sound Bar
: Baby cryr tvate the Parent Unit.
Turn off screen and leave audio on:
:
High: Beep Alarm is issued when rm temperature is higher than
this sng.
Low: Beep Alarm is issued when rm temperature is lwer than this
s ng.
C: Display temperature in Celsius scale.
F
Temperature calibraon
: Display temperature in Fahrenheit scale.
ON: vate rm temperature alarm fun.
OFF
OFF
: Devate rm temperature alarm fun.
: Calibrate rm temperature display tyr
standardize.
Step 1: Mve the parent unit tthe same area as the camera. Bth parent and baby
unit are switc.
Step 2: Select ADD in Menu. The next available camera will autcally be
highlighted. Press “Select” tegin pairing.
Step 3: Within 10 secress “Pairingcamera.
Step 4: Once successfully paired, the camera light will stg and videwill
appearthe mtcreen within 20 sec.
Two different power saving modes
T
OutIn
Zoom
CAM 1
Baby rm temperature
2 3 C
Bery level
Explanaon On/Off :
Reset
Reset
Power
:Prtswitch “
the unit.
Power on off status LED
Steady Green: Parent Unit is pwer.
Steady Orange: Charging bery.
Flash Red: Bery Lw
Power Saving on/off status
Steady Green: Pwer saving mvated.
Sound Level indicator
al indicatr frcked up frm
baby unit.r the rm
Baby unit, the mre LEDs are light.
Power Saving-on/off mode
.
Screen
Microphone
OK/View
and split screen.
and split screen.
:.
Single Screen
:.
Single Screen
Split Screen
Split Screen:.
:.
Talk
.
ated.
Parent Unit
: Email
3
Tips:
.
23 C CAM1
o