AMAX LED-9-WT User manual

Type
User manual

This manual is also suitable for

SAFETY PRECAUTIONS:
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A CERTIFIED ELECTRICIAN FAMILIAR WITH LOCAL MUNICIPAL CODES AND REQUIREMENTS.
3. CAUTION - RISK OF ELECTRIC SHOCK. CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT
BRANCH CIRCUIT CONDUCTOR.
PART QTY A B C D
A 1
B 2
C 3
D 1
E 4
F 4 E F
OPTION #1: JUNCTION BOX MOUNTING
1. Remove glass lens by gently 1. Remove glass lens by gently
rotating and lifting. rotating and lifting.
2. Install the mounting plate with
2. Place mounting screws (included) provided mounting plate screws
in mounting plate screwing in halfway. in your desired direction (screw
Add 1/2" Romex connector (not anchors included).
included) in the center hole and pull Leave mounting screws in the
supply wires from junction box. mounting plate in halfway for
fixture fastening purpose.
3. Install mounting plate before 3. Open blind konckout and install
connecting supply wires to wires on 1/2" Romex connector (not included),
the fixture with wire nuts. Connect fasten conduit or flexible tube.
white to white, black to black, green Connect supply wires to wires on
or bare copper wire to green wire. the fixture with wire nuts. Connect
If wiring to another light, also connect white to white, black to black, green
white to white, black to black, green or bare copper wire to green wire.
or bare copper wire to green wire. If wiring to another light, also connect
white to white, black to black, green
Attach fixture to mounting screws, or bare copper wire to green wire.
turn fixture counter-clockwise to lock.
Secure fixture by tightening mounting
Attach fixture to mounting screws,
screws. turn fixture counter-clockwise to lock.
Secure fixture by tightening mounting
screws.
4. To install glass lens, hold lens up
to fixture, and rotate until notches in 4. To install glass lens, hold lens up
lens line up with tabs in fixture. to fixture, and rotate until notches in
Continue rotating until lens stops. lens line up with tabs in fixture.
Continue rotating until lens stops.
This LED light is compatible to be dimmed by LUTRON #DVCL-153P, MACL-153MH, TGCL-153P,
DV-600P; LEVITON #6633, 6633-P, 6672, 6674, IPL06.
Dimming levels may vary by different dimmer.
Customer service: 888-945-5221
Do not return to store.
Mounting plate screw
Screw anchor
Made in China
LED INDUSTRIAL DRUM
OPTION #2: FIXTURES LINKABLE MOUNTING (NO JUNCTION BOX)
DESCRIPTION
LED light
Mounting screw
Wire nut
Mounting plate
LED-9
  • Page 1 1

AMAX LED-9-WT User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI