FireHawk FHH10 Installation guide

Type
Installation guide

FireHawk FHH10 is an advanced heat alarm featuring thermistor protection, suitable for installation in kitchens, boiler rooms, workshops, and garages where dust, dirt, and moisture may trigger nuisance alarms. This heat alarm is designed to activate when a fire is present, with flames already visible. It is crucial to note that heat alarms should not be installed in escape routes and are not recommended for use in bedrooms, nurseries, playrooms, or areas where elderly or disabled individuals may spend extended periods.

FireHawk FHH10 is an advanced heat alarm featuring thermistor protection, suitable for installation in kitchens, boiler rooms, workshops, and garages where dust, dirt, and moisture may trigger nuisance alarms. This heat alarm is designed to activate when a fire is present, with flames already visible. It is crucial to note that heat alarms should not be installed in escape routes and are not recommended for use in bedrooms, nurseries, playrooms, or areas where elderly or disabled individuals may spend extended periods.

Fireblitz Extinguisher Ltd Units 15/17 Manford Industrial Estate, Manor Road, Erith, Kent DA8 2AJ.
Tel: 01322 342238 | Fax: 01322 331532 | Email: sales@fireblitz.co.uk | www.fireblitz.co.uk
Fireblitz reserve the right to change the design or specification details without prior notice.
REF: SMOKEI&M 01/2021
Heat Alarm
Installation and maintenance
CHOICE AND LOCATION OF ALARMS
1
OPTICAL SMOKE ALARMS are suitable for sensing
smouldering fires in escape routes, lounges and bedrooms
which may contain furniture, bedding and clothes.
HEAT ALARMS are most suitable for kitchens,
boiler rooms, workshops and garages where dust, dirt and
moisture would contribute to nuisance alarms.
NOTE: Heat alarms should not be used in escape routes
and it is recommended they are interlinked to smoke
alarms. Do not install heat alarms on walls or in bedrooms,
nurseries, playrooms or areas where the elderly and
disabled may spend long periods of time.
S
SMOKE ALARMS FOR MINIMUM PROTECTION
SMOKE ALARMS FOR INCREASED PROTECTION
HEAT ALARM
BEDROOM BEDROOM
BEDROOM
BASEMENT
LOUNGE KITCHEN GARAGE
WHERE TO INSTALL
Heat Alarms
FHH10
FEATURING
Advanced
THERMISTOR
Protection
FHH10W
FEATURING
Advanced
THERMISTOR
Protection
ALWAYS read the ENTIRE user manual and keep it in a safe place!
ALWAYS install your alarms in accordance with user manual.
ALWAYS make sure you understand the lights and sounds.
INTERLINK to other smoke alarms and heat alarms if possible.
ALARM POSITIONING
2
MAINTAIN YOUR ALARM
4
HEAT ALARM LOCATION
3
SMOKE ALARMS FOR MINIMUM PROTECTION
SMOKE ALARMS FOR INCREASED PROTECTION
HEAT ALARMS
SMOKE ALARMS FOR MINIMUM PROTECTION
SMOKE ALARMS FOR INCREASED PROTECTION
HEAT ALARMS
Position of alarms
on apex ceilings:
Fireblitz Extinguisher Ltd Units 15/17 Manford Industrial Estate, Manor Road, Erith, Kent DA8 2AJ.
Tel: 01322 342238 | Fax: 01322 331532 | Email: sales@fireblitz.co.uk | www.fireblitz.co.uk
Fireblitz reserve the right to change the design or specification details without prior notice.
REF: SMOKEI&M 01/2021
Test once a week Wipe with damp cloth
every six months
Vacuum with a soft
brush every six months
HEAT ALARMS
REMEMBER, heat alarms need a fire to activate, flames WILL be present.
Do NOT install on walls
Do NOT use in escape routes
If a heat alarm has an interlink facility it should be connected with an interlinkable smoke alarm
Do NOT use in lounges, bedrooms and separate dining rooms where smoke alarms are best
AVOID use in areas where children, the elderly and disabled are normally present
DESIGNED for kitchens, garages, cellars, attics where steam, vapours, dust, and cobwebs may
cause nuisance alarms from smoke alarms
KEEP 300mm AWAY from lights and appliances that generate heat. (Tungsten and low voltage
bulbs) (Sensor temperature range 54°C – 65°C )
KEEP AWAY from objects that could divert or prevent smoke and heat from reaching them, ie
beams and other ceiling features.
KEEP AWAY from extractor fans
HEAT ALARM
  • Page 1 1
  • Page 2 2

FireHawk FHH10 Installation guide

Type
Installation guide

FireHawk FHH10 is an advanced heat alarm featuring thermistor protection, suitable for installation in kitchens, boiler rooms, workshops, and garages where dust, dirt, and moisture may trigger nuisance alarms. This heat alarm is designed to activate when a fire is present, with flames already visible. It is crucial to note that heat alarms should not be installed in escape routes and are not recommended for use in bedrooms, nurseries, playrooms, or areas where elderly or disabled individuals may spend extended periods.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI