Page is loading ...
ENGLIT0000268 00 1
RESPA CF/CFX/FF Heavy Debris Screen Installation Instructions
Sy-Klone part number: RESPASC
Purpose:
The RESPA-CF/CFX/FF Heavy Debris Screen prevents larger items that can
interfere with the fan blades from entering the unit. Recommended for landfill,
agriculture, and mining applications.
PRIOR TO INSTALLING RESPASC:
This installation requires both the Rain Cap and the Finger-Guard Screen. Both
items were included with the Revolution in a Box kit.
• Verify the RESPA unit has an installed rain cap.
• Remove the rain cap if installed and verify that the screened inlet is present.
• The screen will not work with the 4” ducted inlet.
If either or both of these are missing, please order the correct replacement part:
REVA-002 – Adapt The Revolution Kit, which includes all three inlet parts.
Parts Included In Kit:
Stock code Description Quantity
RESPASC RESPA Heavy Debris Screen 1
Tools Required:
#2 Phillips Screwdriver
¼” Socket Driver
¼” x 3” Socket Extension or longer
¼” Thin Wall Deep Socket.
Rain Cap Installed.
Technical Support
www.sy-klone.com
support@sy-klone.com
(904) 448-6563 ext. 1310
Screened Inlet.
Installation Instructions:
1. Remove existing rain cap.
2. Remove 4 sets radial located bolts holding on finger-guard
screened inlet.
3) Place screen over inlet. Slots cut out in screen will match the
two mounting feet on inlet. Holes in bottom of flange will match
mounting hole tabs on inlet.
4. Reinstall 4 sets of radial located bolts holding on inlet. Bolt will
go through screen then original plastic tab. Tighten to 12 in.lb
(1.36 N-m).
5. Reinstall rain cap. Tighten bolt to 20 in.lb (2.26 N-m).
Installation is complete. Thank you for purchasing
genuine Sy-Klone parts.
ENGLIT0000268 00 2
RESPA CF/CFX/FF Heavy Debris Screen Installation Instructions
Radial Screws
Rain Cap
Radial Screws
Rain Cap
/
