2. Elitech
  3. EL-025
EL-025

Elitech EL-025 Assembly Instructions

  • Hello! I am an AI chatbot trained to assist you with the Elitech EL-025 Assembly Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
BASE(×1)
D
TUBE
L=400mm(×1)
C
CABLE CLIP(×1)
E
76
LCD MOUNT
76mm(×2)
B
SPRING WASHER
5/16"(×2)
1
WASHER
8*
13(×2)
2
NYLON NUT
5/16"(×2)
3
WASHER
12.5*
25*T=3(×2)
4
SCREW
M4*P0.7*L12mm
(×8)
9
FOR LCD monitor
9
A
To install LCD Mount(B) in the back of monitor:
Locate mounting screw fixtures on the back
of monitor and attached LCD mount(B) with screw(9).
Make sure the screw(9) match to
your monitor hole to fix the LCD Mount(B).
ALLEN WRENCH
NO.3(×1)
6
ALLEN WRENCH
NO.4(×1)
7
WRENCH
NO.13(×1)
8
FOLD ARM(×1)
A
BRAKE SCREW
M6*P1.0*L6mm(×2)
5
EL-025
Component list
A
E
To route your cable from the cable case
which inside of the Fold arm(A) and the
cable clip(E) for a tidy look.
STEP 4
D
E
F
STEP 3
B
A
4
2
1
3
Installing LCD Mount(B) to Fold arm(A).
8
6
3
4
7
C
E
D
STEP 1
5
A
C
STEP 2
Put the Fold arm(A) through the Tube(C).
To adjust the height of Fold arm(A)
with Allen wrench(7).
Assembly step
Installing Tube(C) on the base(D) and
then put on the Cable clip(E) on
the tube for cable management.
Fixed the brake screw(5) with Allen
wrench(6) to avoid rotation of the tube.
Answer:
Please follow steps below to set the tilting angle
Use a flat-blade screwdriver
to push open the caps.
2.
1.
Locate the two caps which
are on each side of the axis
of the monitor bracket.
3.
Loosen the nut adjust
the tilting angle then
tighten the nutadain.
loose
tighten
WRENCH NO.13
30
90
1.
2.
SCREWDRIVER
Why my monitors keep flopping?
/