Page is loading ...
ACW-2000 R
D: WICHTIGER HINWEIS. BEDIENUNGSANLEITUNG
GB: IMPORTANT INSTRUCTION. USER MANUAL
Instructions for use
Read the instructions carefully before using the device
Safety warnings
- Choose a place close to a power point. Check that the line and socket are in good
condition.
- Before plugging in the product make sure that the cable is in good condition.
- Do not position the device immediately below or above the wall-mounted socket.
- Before switching it on check that the power supply voltage corresponds with the
voltage indicated on the device plate.
- When disconnecting the plug never pull the cable.
- Make sure that during operation the product is not installed in places where air
cannot circulate properly or where it is directing heat at furniture or curtains.
- Do not use the device in the immediate vicinity of a bath, shower or swimming
pool.
- No not use the device near a blind or other flammable material.
- Do not use this product with a programmer or timer or any other device that
switches it on automatically, since there is a fire risk if it is covered or incorrectly
positioned.
- Prevent children from touching the device when it is switched on.
- The device is always used horizontally.
- The fall cut–off feature is an incorporated safety device that cuts the power supply
when the device becomes loose and is vertical.
- Do not use the device in spaces that are not covered
- Never obstruct any of the device’s grilles
- Do not use the device in areas where flammable objects are stored.
- If the power supply cable is damaged, it must be replaced by the authorized
technical services to avoid any danger.
- Do not place the cable in front of the device.
- Do not cover the device either totally or partially, since it can cause deformation
of the component parts.
Components:
1. Filter
2. Cover
3. Computerized control panel
4. Airflow grille
5. Function/Off button
Use:
1. Plug in the device.
Press the Function/Off button once, this will cause the fan’s motor to rotate.
If you press this button:
2 times, the temperature will increase to 1000W.
3 times the temperature will increase to 2000W.
4 times the device will start to oscillate automatically.
5 times, it will switch the device off (the oscillations will end after 30 seconds).
6 times the entire previous cycle will be repeated.
2. Remote control operation
Remove the cover, place two correct size batteries in it.
Operating buttons:
On/Off: pressing this once switches on the device in oscillation mode, pressing it
twice stops the oscillations.
Heating: pressing the button once starts to generate medium hot air.
Pressing it twice the heat will be more intense.
Pressing it 3 times cool air will come out.
Oscillation mode: the oscillation doors open automatically, to stop oscillation
mode the button has to be pressed again.
Timer: the device will switch off automatically 5 or 7. 5 hours later depending on
what has been programmed.
The remote control must be operated from 5 metres away.
MAINTENANCE:
Always unplug the device before cleaning it, use a damp cloth with water, do not use
solvents or similar cleaning products.
INSTALLATION INSTRUCTIONS:
Make two holes in the wall about 1.80 m off the floor, the distance between the holes
should be 5.7 cm.
Put the wall plugs in the holes and press them in, then screw the device to the wall.
Make sure that the device is securely fastened to the wall.
Service
: PVG Deutschland GmbH,
Telefon: +49 (0) 800 - 9427622
Fax: +49 (0) 180 - 5251450
/