TECHNOLOGY
Zonable termination and trouble-shooting point for IR repeating systems
INSTALLATION MANUAL
IRZ-1
SPECIFICATIONS
Connectors: Screw-type
Emitter outputs: (7) 1/8" mini-jacks
Power supply: +12vdc power supply, unregulated (included)
Dimensions: 6.75"H x 1.625"W x 1"D
Extra Emitter Jack: Allows for an extra Emitter (or 4 extra emitters using the Audioplex IRS-1).
The IRZ-1 provides a convenient zonable connecting point and trouble shooting station for a remote relay system, eliminating hard-
wiring. Each room has it's own screw-down connector for the IRTarget, each emitter and the power supplies have their own plug-in
jacks. Every IRBug(Stick-emit) or IRFlood(TBW) has it's own visible LED which flashes to verify operation. Follow the wiring
diagram below for basic set up. To create specific zones use the wiring diagram on the back of this page.
The IRZ-1 includes a jack for an optional 12vdc wall adapter. By plugging the adapter into your receiver's switched AC outlet, you
will provide SYS-TAT power whenever the receiver is turned on.
2003 - 8/13/03
TO BE USED WITH AUDIOPLEX BRAND IR ONLY!
MMX-40
IRBug-PL
RED 15V (B+)
RED 15V (B+)
BLACK (G)
BLACK (G)
YELLOW (S)
YELLOW (S)
BLUE (Optional SYS-TAT)
Stealth Sensor
StealthX40-HW
disc 5 2.53
tape b
DVD DOLBY DIGITAL
T
V
S
G
T
V
S
G
T
V
S
G
T
V
S
G
T
V
S
G
T
V
S
G
EMITTERS
STATUS(T)
EMITTERS
POWER(V)
1
2
3
4
5
6
UNREGULATED
12 VDC POWER SUPPLY
12 VDC POWER SUPPLY
OUT TO ADDITIONAL EMITTERS
IRS-1
(optional for SYS-TAT)
IRZ-1
WIRING DIAGRAM