2. AMP
  3. HSD1

AMP HSD1 Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the AMP HSD1 Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
For Technical Support, Contact AMP
at (775) 345-9933 (9 am - 5 pm PST)
or engineering@advmw.com
Connect amplier RF output SMA connector to antenna
Connect the RF output from the CDT1 video transmitter to
RF input SMA connector.
STEP
STEP
STEP
Note
When setting up your system, the transmit and receive
antennas should be greater than 25 feet apart to
prevent serious damage to or destruction of the
receiver’s front end
HSD1 Power Amplifier Quick Start Guide
Connect power, Communications (if required), and
enable inputs to the MDM-9P connector *see reverse side
AQS-HSD1-B
Advanced Microwave Products
8748 Technology Way
Reno, NV 89521
Phone: (775) 345-9933
How to Congure Your Amplier
The HSD1 power amplier does not require any conguring unless it includes optional variable
output level. If included, the power level is set via commands using the Comm port. See the HSD1
Interface Control Document (ICD) for more details.
SMA Female
RF Input
SMA Female
RF Output
Wiring Your HSD1 Power Amplier
MDM-9P
Power & Conguration
1:
2:
3:
4:
5:
6:
7:
8:
9:
+11 to 16 VDC Input
Ground
Ground
Ground
Enable (Open=On, Ground (or <1.5 Vdc)=O)
NC/Tx Comm-
Tx Comm+
Rx Comm+
NC/Rx Comm-
1 5
6 9
/